[Qemu-devel] [PULL 32/42] hw/arm/nseries: Use TYPE_TMP105 instead of hardcoded string

[Peter Maydell <peter.maydell@linaro.org>]

From: Philippe Mathieu-Daudé <philmd@redhat.com>

Suggested-by: Markus Armbruster <armbru@redhat.com>
Signed-off-by: Philippe Mathieu-Daudé <philmd@redhat.com>
Message-id: 20190412165416.7977-3-philmd@redhat.com
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
---
 hw/arm/nseries.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/hw/arm/nseries.c b/hw/arm/nseries.c
index 906b7ca22d4..2b710c3d49f 100644
--- a/hw/arm/nseries.c
+++ b/hw/arm/nseries.c
@@ -31,6 +31,7 @@
 #include "hw/boards.h"
 #include "hw/i2c/i2c.h"
 #include "hw/devices.h"
+#include "hw/misc/tmp105.h"
 #include "hw/block/flash.h"
 #include "hw/hw.h"
 #include "hw/bt.h"
@@ -218,7 +219,7 @@ static void n8x0_i2c_setup(struct n800_s *s)
     qemu_register_powerdown_notifier(&n8x0_system_powerdown_notifier);
 
     /* Attach a TMP105 PM chip (A0 wired to ground) */
-    dev = i2c_create_slave(i2c, "tmp105", N8X0_TMP105_ADDR);
+    dev = i2c_create_slave(i2c, TYPE_TMP105, N8X0_TMP105_ADDR);
     qdev_connect_gpio_out(dev, 0, tmp_irq);
 }
 
-- 
2.20.1