[PULL 19/29] qga/qapi-schema.json: Add some headings

[Markus Armbruster <armbru@redhat.com>]

From: Peter Maydell <peter.maydell@linaro.org>

Add some section headings to the QGA json; this is purely so that we
have some H1 headings, as otherwise each command ends up being
visible in the interop/ manual's table of contents.  In an ideal
world there might be a proper 'Introduction' section the way there is
in qapi/qapi-schema.json.

Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Message-Id: <20200925162316.21205-12-peter.maydell@linaro.org>
Reviewed-by: Markus Armbruster <armbru@redhat.com>
Signed-off-by: Markus Armbruster <armbru@redhat.com>
---
 qga/qapi-schema.json | 8 +++++---
 1 file changed, 5 insertions(+), 3 deletions(-)

diff --git a/qga/qapi-schema.json b/qga/qapi-schema.json
index d2ea7446db..cec98c7e06 100644
--- a/qga/qapi-schema.json
+++ b/qga/qapi-schema.json
@@ -2,14 +2,16 @@
 # vim: filetype=python
 
 ##
-#
-# General note concerning the use of guest agent interfaces:
+# = General note concerning the use of guest agent interfaces
 #
 # "unsupported" is a higher-level error than the errors that individual
 # commands might document. The caller should always be prepared to receive
 # QERR_UNSUPPORTED, even if the given command doesn't specify it, or doesn't
 # document any failure mode at all.
-#
+##
+
+##
+# = QEMU guest agent protocol commands and structs
 ##
 
 { 'pragma': { 'doc-required': true } }
-- 
2.26.2