[PATCH 3/3] avr/arduino: Add D13 LED

[G S Niteesh Babu <niteesh.gs@gmail.com>]

Signed-off-by: G S Niteesh Babu <niteesh.gs@gmail.com>
---
 hw/avr/Kconfig   |  1 +
 hw/avr/arduino.c | 15 +++++++++++++++
 2 files changed, 16 insertions(+)

diff --git a/hw/avr/Kconfig b/hw/avr/Kconfig
index 16a57ced11..e0d4fc5537 100644
--- a/hw/avr/Kconfig
+++ b/hw/avr/Kconfig
@@ -8,3 +8,4 @@ config AVR_ATMEGA_MCU
 config ARDUINO
     select AVR_ATMEGA_MCU
     select UNIMP
+    select LED
diff --git a/hw/avr/arduino.c b/hw/avr/arduino.c
index 3c8388490d..5cdba3201c 100644
--- a/hw/avr/arduino.c
+++ b/hw/avr/arduino.c
@@ -13,6 +13,7 @@
 #include "qemu/osdep.h"
 #include "qapi/error.h"
 #include "hw/boards.h"
+#include "hw/misc/led.h"
 #include "atmega.h"
 #include "boot.h"
 #include "qom/object.h"
@@ -22,6 +23,8 @@ struct ArduinoMachineState {
     MachineState parent_obj;
     /*< public >*/
     AtmegaMcuState mcu;
+
+    LEDState *onboard_led;
 };
 typedef struct ArduinoMachineState ArduinoMachineState;
 
@@ -49,6 +52,18 @@ static void arduino_machine_init(MachineState *machine)
                              amc->xtal_hz, &error_abort);
     sysbus_realize(SYS_BUS_DEVICE(&ams->mcu), &error_abort);
 
+    ams->onboard_led = led_create_simple(OBJECT(ams),
+                                         GPIO_POLARITY_ACTIVE_HIGH,
+                                         LED_COLOR_BLUE,
+                                         "D13 LED");
+
+    /* TODO: Add macro or function to map pins to ports */
+    /* The onboard led is connected to PIN 13 in all boards currently supported
+     * in QEMU. And PIN 13 is mapped to PORT B BIT 5.
+     */
+    qdev_connect_gpio_out(DEVICE(&ams->mcu.gpio[1]), 5,
+                          qdev_get_gpio_in(DEVICE(ams->onboard_led), 0));
+
     if (machine->firmware) {
         if (!avr_load_firmware(&ams->mcu.cpu, machine,
                                &ams->mcu.flash, machine->firmware)) {
-- 
2.17.1