[PULL 04/15] target/mips: Raise exception when DINSV opcode used with DSP disabled

["Philippe Mathieu-Daudé" <f4bug@amsat.org>]

Per the "MIPS® DSP Module for MIPS64 Architecture" manual, rev. 3.02,
Table 5.3 "SPECIAL3 Encoding of Function Field for DSP Module":

  If the Module/ASE is not implemented, executing such an instruction
  must cause a Reserved Instruction Exception.

The DINSV instruction lists the following exceptions:
- Reserved Instruction
- DSP Disabled

If the MIPS core doesn't support the DSP module, or the DSP is
disabled, do not handle the '$rt = $0' case as a no-op but raise
the proper exception instead.

Cc: Jia Liu <proljc@gmail.com>
Fixes: 1cb6686cf92 ("target-mips: Add ASE DSP bit/manipulation instructions")
Signed-off-by: Philippe Mathieu-Daudé <f4bug@amsat.org>
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Message-Id: <20210529165443.1114402-1-f4bug@amsat.org>
---
 target/mips/tcg/translate.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/target/mips/tcg/translate.c b/target/mips/tcg/translate.c
index 09b19262c8c..3fd0c48d772 100644
--- a/target/mips/tcg/translate.c
+++ b/target/mips/tcg/translate.c
@@ -24379,10 +24379,11 @@ static void decode_opc_special3_legacy(CPUMIPSState *env, DisasContext *ctx)
         {
             TCGv t0, t1;
 
+            check_dsp(ctx);
+
             if (rt == 0) {
                 break;
             }
-            check_dsp(ctx);
 
             t0 = tcg_temp_new();
             t1 = tcg_temp_new();
-- 
2.31.1