[PATCH 09/14] hw/intc/arm_gicv3: Set GICR_CTLR.CES if LPIs are supported

[Peter Maydell <peter.maydell@linaro.org>]

The GICR_CTLR.CES bit is a read-only bit which is set to 1 to indicate
that the GICR_CTLR.EnableLPIs bit can be written to 0 to disable
LPIs (as opposed to allowing LPIs to be enabled but not subsequently
disabled). Our implementation permits this, so advertise it
by setting CES to 1.

Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
---
 hw/intc/gicv3_internal.h   | 1 +
 hw/intc/arm_gicv3_common.c | 4 ++++
 2 files changed, 5 insertions(+)

diff --git a/hw/intc/gicv3_internal.h b/hw/intc/gicv3_internal.h
index 5394266aaf4..a316f6c58a5 100644
--- a/hw/intc/gicv3_internal.h
+++ b/hw/intc/gicv3_internal.h
@@ -110,6 +110,7 @@
 #define GICR_NSACR            (GICR_SGI_OFFSET + 0x0E00)
 
 #define GICR_CTLR_ENABLE_LPIS        (1U << 0)
+#define GICR_CTLR_CES                (1U << 1)
 #define GICR_CTLR_RWP                (1U << 3)
 #define GICR_CTLR_DPG0               (1U << 24)
 #define GICR_CTLR_DPG1NS             (1U << 25)
diff --git a/hw/intc/arm_gicv3_common.c b/hw/intc/arm_gicv3_common.c
index 579aa0cb9ed..4ca5ae9bc56 100644
--- a/hw/intc/arm_gicv3_common.c
+++ b/hw/intc/arm_gicv3_common.c
@@ -429,6 +429,10 @@ static void arm_gicv3_common_reset(DeviceState *dev)
 
         cs->level = 0;
         cs->gicr_ctlr = 0;
+        if (s->lpi_enable) {
+            /* Our implementation supports clearing GICR_CTLR.EnableLPIs */
+            cs->gicr_ctlr |= GICR_CTLR_CES;
+        }
         cs->gicr_statusr[GICV3_S] = 0;
         cs->gicr_statusr[GICV3_NS] = 0;
         cs->gicr_waker = GICR_WAKER_ProcessorSleep | GICR_WAKER_ChildrenAsleep;
-- 
2.25.1