From: Jean-Philippe Brucker <jean-philippe@linaro.org>
To: peter.maydell@linaro.org
Cc: richard.henderson@linaro.org, qemu-arm@nongnu.org,
qemu-devel@nongnu.org,
Jean-Philippe Brucker <jean-philippe@linaro.org>
Subject: [PATCH v3 4/6] target/arm: Pass security space rather than flag for AT instructions
Date: Wed, 9 Aug 2023 13:37:04 +0100 [thread overview]
Message-ID: <20230809123706.1842548-5-jean-philippe@linaro.org> (raw)
In-Reply-To: <20230809123706.1842548-1-jean-philippe@linaro.org>
At the moment we only handle Secure and Nonsecure security spaces for
the AT instructions. Add support for Realm and Root.
For AArch64, arm_security_space() gives the desired space. ARM DDI0487J
says (R_NYXTL):
If EL3 is implemented, then when an address translation instruction
that applies to an Exception level lower than EL3 is executed, the
Effective value of SCR_EL3.{NSE, NS} determines the target Security
state that the instruction applies to.
For AArch32, some instructions can access NonSecure space from Secure,
so we still need to pass the state explicitly to do_ats_write().
Signed-off-by: Jean-Philippe Brucker <jean-philippe@linaro.org>
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
---
target/arm/internals.h | 18 +++++++++---------
target/arm/helper.c | 27 ++++++++++++---------------
target/arm/ptw.c | 12 ++++++------
3 files changed, 27 insertions(+), 30 deletions(-)
diff --git a/target/arm/internals.h b/target/arm/internals.h
index fc90c364f7..cf13bb94f5 100644
--- a/target/arm/internals.h
+++ b/target/arm/internals.h
@@ -1217,24 +1217,24 @@ bool get_phys_addr(CPUARMState *env, target_ulong address,
__attribute__((nonnull));
/**
- * get_phys_addr_with_secure_nogpc: get the physical address for a virtual
- * address
+ * get_phys_addr_with_space_nogpc: get the physical address for a virtual
+ * address
* @env: CPUARMState
* @address: virtual address to get physical address for
* @access_type: 0 for read, 1 for write, 2 for execute
* @mmu_idx: MMU index indicating required translation regime
- * @is_secure: security state for the access
+ * @space: security space for the access
* @result: set on translation success.
* @fi: set to fault info if the translation fails
*
- * Similar to get_phys_addr, but use the given security regime and don't perform
+ * Similar to get_phys_addr, but use the given security space and don't perform
* a Granule Protection Check on the resulting address.
*/
-bool get_phys_addr_with_secure_nogpc(CPUARMState *env, target_ulong address,
- MMUAccessType access_type,
- ARMMMUIdx mmu_idx, bool is_secure,
- GetPhysAddrResult *result,
- ARMMMUFaultInfo *fi)
+bool get_phys_addr_with_space_nogpc(CPUARMState *env, target_ulong address,
+ MMUAccessType access_type,
+ ARMMMUIdx mmu_idx, ARMSecuritySpace space,
+ GetPhysAddrResult *result,
+ ARMMMUFaultInfo *fi)
__attribute__((nonnull));
bool pmsav8_mpu_lookup(CPUARMState *env, uint32_t address,
diff --git a/target/arm/helper.c b/target/arm/helper.c
index 427de6bd2a..fbb03c364b 100644
--- a/target/arm/helper.c
+++ b/target/arm/helper.c
@@ -3357,7 +3357,7 @@ static int par_el1_shareability(GetPhysAddrResult *res)
static uint64_t do_ats_write(CPUARMState *env, uint64_t value,
MMUAccessType access_type, ARMMMUIdx mmu_idx,
- bool is_secure)
+ ARMSecuritySpace ss)
{
bool ret;
uint64_t par64;
@@ -3369,8 +3369,8 @@ static uint64_t do_ats_write(CPUARMState *env, uint64_t value,
* I_MXTJT: Granule protection checks are not performed on the final address
* of a successful translation.
*/
- ret = get_phys_addr_with_secure_nogpc(env, value, access_type, mmu_idx,
- is_secure, &res, &fi);
+ ret = get_phys_addr_with_space_nogpc(env, value, access_type, mmu_idx, ss,
+ &res, &fi);
/*
* ATS operations only do S1 or S1+S2 translations, so we never
@@ -3535,7 +3535,7 @@ static void ats_write(CPUARMState *env, const ARMCPRegInfo *ri, uint64_t value)
uint64_t par64;
ARMMMUIdx mmu_idx;
int el = arm_current_el(env);
- bool secure = arm_is_secure_below_el3(env);
+ ARMSecuritySpace ss = arm_security_space(env);
switch (ri->opc2 & 6) {
case 0:
@@ -3543,10 +3543,9 @@ static void ats_write(CPUARMState *env, const ARMCPRegInfo *ri, uint64_t value)
switch (el) {
case 3:
mmu_idx = ARMMMUIdx_E3;
- secure = true;
break;
case 2:
- g_assert(!secure); /* ARMv8.4-SecEL2 is 64-bit only */
+ g_assert(ss != ARMSS_Secure); /* ARMv8.4-SecEL2 is 64-bit only */
/* fall through */
case 1:
if (ri->crm == 9 && (env->uncached_cpsr & CPSR_PAN)) {
@@ -3564,10 +3563,9 @@ static void ats_write(CPUARMState *env, const ARMCPRegInfo *ri, uint64_t value)
switch (el) {
case 3:
mmu_idx = ARMMMUIdx_E10_0;
- secure = true;
break;
case 2:
- g_assert(!secure); /* ARMv8.4-SecEL2 is 64-bit only */
+ g_assert(ss != ARMSS_Secure); /* ARMv8.4-SecEL2 is 64-bit only */
mmu_idx = ARMMMUIdx_Stage1_E0;
break;
case 1:
@@ -3580,18 +3578,18 @@ static void ats_write(CPUARMState *env, const ARMCPRegInfo *ri, uint64_t value)
case 4:
/* stage 1+2 NonSecure PL1: ATS12NSOPR, ATS12NSOPW */
mmu_idx = ARMMMUIdx_E10_1;
- secure = false;
+ ss = ARMSS_NonSecure;
break;
case 6:
/* stage 1+2 NonSecure PL0: ATS12NSOUR, ATS12NSOUW */
mmu_idx = ARMMMUIdx_E10_0;
- secure = false;
+ ss = ARMSS_NonSecure;
break;
default:
g_assert_not_reached();
}
- par64 = do_ats_write(env, value, access_type, mmu_idx, secure);
+ par64 = do_ats_write(env, value, access_type, mmu_idx, ss);
A32_BANKED_CURRENT_REG_SET(env, par, par64);
#else
@@ -3608,7 +3606,8 @@ static void ats1h_write(CPUARMState *env, const ARMCPRegInfo *ri,
uint64_t par64;
/* There is no SecureEL2 for AArch32. */
- par64 = do_ats_write(env, value, access_type, ARMMMUIdx_E2, false);
+ par64 = do_ats_write(env, value, access_type, ARMMMUIdx_E2,
+ ARMSS_NonSecure);
A32_BANKED_CURRENT_REG_SET(env, par, par64);
#else
@@ -3633,7 +3632,6 @@ static void ats_write64(CPUARMState *env, const ARMCPRegInfo *ri,
#ifdef CONFIG_TCG
MMUAccessType access_type = ri->opc2 & 1 ? MMU_DATA_STORE : MMU_DATA_LOAD;
ARMMMUIdx mmu_idx;
- int secure = arm_is_secure_below_el3(env);
uint64_t hcr_el2 = arm_hcr_el2_eff(env);
bool regime_e20 = (hcr_el2 & (HCR_E2H | HCR_TGE)) == (HCR_E2H | HCR_TGE);
@@ -3653,7 +3651,6 @@ static void ats_write64(CPUARMState *env, const ARMCPRegInfo *ri,
break;
case 6: /* AT S1E3R, AT S1E3W */
mmu_idx = ARMMMUIdx_E3;
- secure = true;
break;
default:
g_assert_not_reached();
@@ -3673,7 +3670,7 @@ static void ats_write64(CPUARMState *env, const ARMCPRegInfo *ri,
}
env->cp15.par_el[1] = do_ats_write(env, value, access_type,
- mmu_idx, secure);
+ mmu_idx, arm_security_space(env));
#else
/* Handled by hardware accelerator. */
g_assert_not_reached();
diff --git a/target/arm/ptw.c b/target/arm/ptw.c
index 33179f3471..6c5ecd37cd 100644
--- a/target/arm/ptw.c
+++ b/target/arm/ptw.c
@@ -3418,15 +3418,15 @@ static bool get_phys_addr_gpc(CPUARMState *env, S1Translate *ptw,
return false;
}
-bool get_phys_addr_with_secure_nogpc(CPUARMState *env, target_ulong address,
- MMUAccessType access_type,
- ARMMMUIdx mmu_idx, bool is_secure,
- GetPhysAddrResult *result,
- ARMMMUFaultInfo *fi)
+bool get_phys_addr_with_space_nogpc(CPUARMState *env, target_ulong address,
+ MMUAccessType access_type,
+ ARMMMUIdx mmu_idx, ARMSecuritySpace space,
+ GetPhysAddrResult *result,
+ ARMMMUFaultInfo *fi)
{
S1Translate ptw = {
.in_mmu_idx = mmu_idx,
- .in_space = arm_secure_to_space(is_secure),
+ .in_space = space,
};
return get_phys_addr_nogpc(env, &ptw, address, access_type, result, fi);
}
--
2.41.0
next prev parent reply other threads:[~2023-08-09 12:39 UTC|newest]
Thread overview: 9+ messages / expand[flat|nested] mbox.gz Atom feed top
2023-08-09 12:37 [PATCH v3 0/6] target/arm: Fixes for RME Jean-Philippe Brucker
2023-08-09 12:37 ` [PATCH v3 1/6] target/arm/ptw: Load stage-2 tables from realm physical space Jean-Philippe Brucker
2023-08-09 12:37 ` [PATCH v3 2/6] target/arm/helper: Fix tlbmask and tlbbits for TLBI VAE2* Jean-Philippe Brucker
2023-08-09 12:37 ` [PATCH v3 3/6] target/arm: Skip granule protection checks for AT instructions Jean-Philippe Brucker
2023-08-09 12:37 ` Jean-Philippe Brucker [this message]
2023-08-09 12:37 ` [PATCH v3 5/6] target/arm/helper: Check SCR_EL3.{NSE, NS} encoding " Jean-Philippe Brucker
2023-08-09 12:37 ` [PATCH v3 6/6] target/arm/helper: Implement CNTHCTL_EL2.CNT[VP]MASK Jean-Philippe Brucker
2023-08-10 13:16 ` [PATCH v3 0/6] target/arm: Fixes for RME Peter Maydell
2023-08-10 13:36 ` Jean-Philippe Brucker
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20230809123706.1842548-5-jean-philippe@linaro.org \
--to=jean-philippe@linaro.org \
--cc=peter.maydell@linaro.org \
--cc=qemu-arm@nongnu.org \
--cc=qemu-devel@nongnu.org \
--cc=richard.henderson@linaro.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).