[PULL 11/13] vfio/migration: Block VFIO migration with postcopy migration

["Cédric Le Goater" <clg@redhat.com>]

From: Avihai Horon <avihaih@nvidia.com>

VFIO migration is not compatible with postcopy migration. A VFIO device
in the destination can't handle page faults for pages that have not been
sent yet.

Doing such migration will cause the VM to crash in the destination:

qemu-system-x86_64: VFIO_MAP_DMA failed: Bad address
qemu-system-x86_64: vfio_dma_map(0x55a28c7659d0, 0xc0000, 0xb000, 0x7f1b11a00000) = -14 (Bad address)
qemu: hardware error: vfio: DMA mapping failed, unable to continue

To prevent this, block VFIO migration with postcopy migration.

Reported-by: Yanghang Liu <yanghliu@redhat.com>
Signed-off-by: Avihai Horon <avihaih@nvidia.com>
Tested-by: Yanghang Liu <yanghliu@redhat.com>
Reviewed-by: Peter Xu <peterx@redhat.com>
Signed-off-by: Cédric Le Goater <clg@redhat.com>
---
 hw/vfio/migration.c | 22 ++++++++++++++++++++++
 1 file changed, 22 insertions(+)

diff --git a/hw/vfio/migration.c b/hw/vfio/migration.c
index 71855468fe985291e2d009b81c6efd29abcbe755..20994dc1d60b1606728415fec17c19cfd00c4dee 100644
--- a/hw/vfio/migration.c
+++ b/hw/vfio/migration.c
@@ -335,6 +335,27 @@ static bool vfio_precopy_supported(VFIODevice *vbasedev)
 
 /* ---------------------------------------------------------------------- */
 
+static int vfio_save_prepare(void *opaque, Error **errp)
+{
+    VFIODevice *vbasedev = opaque;
+
+    /*
+     * Snapshot doesn't use postcopy, so allow snapshot even if postcopy is on.
+     */
+    if (runstate_check(RUN_STATE_SAVE_VM)) {
+        return 0;
+    }
+
+    if (migrate_postcopy_ram()) {
+        error_setg(
+            errp, "%s: VFIO migration is not supported with postcopy migration",
+            vbasedev->name);
+        return -EOPNOTSUPP;
+    }
+
+    return 0;
+}
+
 static int vfio_save_setup(QEMUFile *f, void *opaque)
 {
     VFIODevice *vbasedev = opaque;
@@ -640,6 +661,7 @@ static bool vfio_switchover_ack_needed(void *opaque)
 }
 
 static const SaveVMHandlers savevm_vfio_handlers = {
+    .save_prepare = vfio_save_prepare,
     .save_setup = vfio_save_setup,
     .save_cleanup = vfio_save_cleanup,
     .state_pending_estimate = vfio_state_pending_estimate,
-- 
2.41.0