[RFC PATCH-for-9.0 v2 13/19] hw/xen: Remove use of 'target_ulong' in handle_ioreq()

["Philippe Mathieu-Daudé" <philmd@linaro.org>]

Per commit f17068c1c7 ("xen-hvm: reorganize xen-hvm and move common
function to xen-hvm-common"), handle_ioreq() is expected to be
target-agnostic. However it uses 'target_ulong', which is a target
specific definition.

Per xen/include/public/hvm/ioreq.h header:

  struct ioreq {
    uint64_t addr;          /* physical address */
    uint64_t data;          /* data (or paddr of data) */
    uint32_t count;         /* for rep prefixes */
    uint32_t size;          /* size in bytes */
    uint32_t vp_eport;      /* evtchn for notifications to/from device model */
    uint16_t _pad0;
    uint8_t state:4;
    uint8_t data_is_ptr:1;  /* if 1, data above is the guest paddr
                             * of the real data to use. */
    uint8_t dir:1;          /* 1=read, 0=write */
    uint8_t df:1;
    uint8_t _pad1:1;
    uint8_t type;           /* I/O type */
  };
  typedef struct ioreq ioreq_t;

If 'data' is not a pointer, it is a u64.

- In PIO / VMWARE_PORT modes, only 32-bit are used.

- In MMIO COPY mode, memory is accessed by chunks of 64-bit

- In PCI_CONFIG mode, access is u8 or u16 or u32.

- None of TIMEOFFSET / INVALIDATE use 'req'.

- Fallback is only used in x86 for VMWARE_PORT.

Masking the upper bits of 'data' to keep 'req->size' low bits
is irrelevant of the target word size. Remove the word size
check and always extract the relevant bits.

Signed-off-by: Philippe Mathieu-Daudé <philmd@linaro.org>
---
 hw/xen/xen-hvm-common.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/hw/xen/xen-hvm-common.c b/hw/xen/xen-hvm-common.c
index bb3cfb200c..fb81bd8fbc 100644
--- a/hw/xen/xen-hvm-common.c
+++ b/hw/xen/xen-hvm-common.c
@@ -1,5 +1,6 @@
 #include "qemu/osdep.h"
 #include "qemu/units.h"
+#include "qemu/bitops.h"
 #include "qapi/error.h"
 #include "trace.h"
 
@@ -426,9 +427,8 @@ static void handle_ioreq(XenIOState *state, ioreq_t *req)
     trace_handle_ioreq(req, req->type, req->dir, req->df, req->data_is_ptr,
                        req->addr, req->data, req->count, req->size);
 
-    if (!req->data_is_ptr && (req->dir == IOREQ_WRITE) &&
-            (req->size < sizeof (target_ulong))) {
-        req->data &= ((target_ulong) 1 << (8 * req->size)) - 1;
+    if (!req->data_is_ptr && (req->dir == IOREQ_WRITE)) {
+        req->data = extract64(req->data, 0, BITS_PER_BYTE * req->size);
     }
 
     if (req->dir == IOREQ_WRITE)
-- 
2.41.0