[PULL 8/9] ide/via: don't attempt to set default BAR addresses

[Kevin Wolf <kwolf@redhat.com>]

From: Mark Cave-Ayland <mark.cave-ayland@ilande.co.uk>

The via-ide device currently attempts to set the default BAR addresses to the
values shown in the datasheet, but this doesn't work for 2 reasons: firstly
BARS 1-4 do not set the bottom 2 bits to PCI_BASE_ADDRESS_SPACE_IO, and
secondly the initial PCI bus reset clears the values of all PCI device BARs
after the device itself has been reset.

Remove the setting of the default BAR addresses from via_ide_reset() to ensure
there is no doubt that these values are never exposed to the guest.

Signed-off-by: Mark Cave-Ayland <mark.cave-ayland@ilande.co.uk>
Message-ID: <20231116103355.588580-4-mark.cave-ayland@ilande.co.uk>
Reviewed-by: Kevin Wolf <kwolf@redhat.com>
Reviewed-by: Philippe Mathieu-Daudé <philmd@linaro.org>
Signed-off-by: Kevin Wolf <kwolf@redhat.com>
---
 hw/ide/via.c | 5 -----
 1 file changed, 5 deletions(-)

diff --git a/hw/ide/via.c b/hw/ide/via.c
index fff23803a6..87b134083a 100644
--- a/hw/ide/via.c
+++ b/hw/ide/via.c
@@ -132,11 +132,6 @@ static void via_ide_reset(DeviceState *dev)
     pci_set_word(pci_conf + PCI_STATUS, PCI_STATUS_FAST_BACK |
                  PCI_STATUS_DEVSEL_MEDIUM);
 
-    pci_set_long(pci_conf + PCI_BASE_ADDRESS_0, 0x000001f0);
-    pci_set_long(pci_conf + PCI_BASE_ADDRESS_1, 0x000003f4);
-    pci_set_long(pci_conf + PCI_BASE_ADDRESS_2, 0x00000170);
-    pci_set_long(pci_conf + PCI_BASE_ADDRESS_3, 0x00000374);
-    pci_set_long(pci_conf + PCI_BASE_ADDRESS_4, 0x0000cc01); /* BMIBA: 20-23h */
     pci_set_long(pci_conf + PCI_INTERRUPT_LINE, 0x0000010e);
 
     /* IDE chip enable, IDE configuration 1/2, IDE FIFO Configuration*/
-- 
2.42.0