[PULL 01/34] scsi: add conversion from ENODEV to sense

[Paolo Bonzini <pbonzini@redhat.com>]

This is mostly for completeness; I noticed it because ENODEV is used internally
within scsi-disk.c, but when scsi_sense_from_errno(ENODEV) is called the resulting
sense is never used and instead scsi_sense_from_host_status() is called later
by scsi_req_complete_failed().

Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
---
 scsi/utils.c | 13 ++++++++++---
 1 file changed, 10 insertions(+), 3 deletions(-)

diff --git a/scsi/utils.c b/scsi/utils.c
index 357b0366716..545956f4f95 100644
--- a/scsi/utils.c
+++ b/scsi/utils.c
@@ -587,20 +587,27 @@ int scsi_sense_from_errno(int errno_value, SCSISense *sense)
         return GOOD;
     case EDOM:
         return TASK_SET_FULL;
+#if ENODEV != ENOMEDIUM
+    case ENODEV:
+        /*
+         * Some of the BSDs have ENODEV and ENOMEDIUM as synonyms.  For
+         * everyone else, give a more severe sense code for ENODEV.
+         */
+#endif
 #ifdef CONFIG_LINUX
         /* These errno mapping are specific to Linux.  For more information:
          * - scsi_check_sense and scsi_decide_disposition in drivers/scsi/scsi_error.c
          * - scsi_result_to_blk_status in drivers/scsi/scsi_lib.c
          * - blk_errors[] in block/blk-core.c
          */
+    case EREMOTEIO:
+        *sense = SENSE_CODE(TARGET_FAILURE);
+        return CHECK_CONDITION;
     case EBADE:
         return RESERVATION_CONFLICT;
     case ENODATA:
         *sense = SENSE_CODE(READ_ERROR);
         return CHECK_CONDITION;
-    case EREMOTEIO:
-        *sense = SENSE_CODE(TARGET_FAILURE);
-        return CHECK_CONDITION;
 #endif
     case ENOMEDIUM:
         *sense = SENSE_CODE(NO_MEDIUM);
-- 
2.49.0