Re: [Qemu-devel] Missing Diag/Debug Registers in lsi53c895a emulation

[Peter Lieven <pl@kamp.de>]

On 12.01.2015 10:28, Peter Lieven wrote:
> Hi,
>
> while trying to run an ASA1000V appliance I found that registers 0x09 and 0x3c-3f are read during boot up. Which
> currently results in an exit(1). The appliance uses an quite ancient 2.6.29.6 Linux kernel.
> These registers are mainly for diag and debug purposes so I came up with the following patch. The system works
> with the following patch, but I wonder if this is a correct workaround:

Maybe this is better:

diff --git a/hw/scsi/lsi53c895a.c b/hw/scsi/lsi53c895a.c
index ec92048..db7d4b8 100644
--- a/hw/scsi/lsi53c895a.c
+++ b/hw/scsi/lsi53c895a.c
@@ -277,6 +277,7 @@ typedef struct {
      uint32_t csbc;
      uint32_t scratch[18]; /* SCRATCHA-SCRATCHR */
      uint8_t sbr;
+    uint32_t adder;

      /* Script ram is stored as 32-bit words in host byteorder.  */
      uint32_t script_ram[2048];
@@ -1389,6 +1390,7 @@ again:
                  switch ((insn >> 27) & 7) {
                  case 0: /* Jump */
                      DPRINTF("Jump to 0x%08x\n", addr);
+                    s->adder = addr;
                      s->dsp = addr;
                      break;
                  case 1: /* Call */
@@ -1513,6 +1515,8 @@ static uint8_t lsi_reg_readb(LSIState *s, int offset)
          return 0x7f;
      case 0x08: /* Revision ID */
          return 0x00;
+    case 0x09: /* SOCL */
+        return s->socl;
      case 0xa: /* SSID */
          return s->ssid;
      case 0xb: /* SBCL */
@@ -1577,6 +1581,8 @@ static uint8_t lsi_reg_readb(LSIState *s, int offset)
          return s->sbr;
      case 0x3b: /* DCNTL */
          return s->dcntl;
+    /* ADDER Output (Debug of relative jump address) */
+    CASE_GET_REG32(adder, 0x3c)
      case 0x40: /* SIEN0 */
          return s->sien0;
      case 0x41: /* SIEN1 */