Re: [Qemu-devel] unknown keycodes `(unnamed)', please report to

[Peter Maydell <peter.maydell@linaro.org>]

On Thu, 24 Jan 2019 at 13:30, Burgess, Alison E <alison.burgess@wsu.edu> wrote:
> I am running Ubuntu 18.04 and I am sending this email because when I try to run these series of commands in an executable file in
>
>
> arm-none-eabi-as -mcpu=arm926ej-s -g ts.s -o ts.o
> arm-none-eabi-gcc -c -mcpu=arm926ej-s -g t.c -o t.o
> arm-none-eabi-ld -T t.ld ts.o t.o -o t.elf
> arm-none-eabi-objcopy -O binary t.elf t.bin
> arm-none-eabi-readelf -a t.elf
>
> rm *.o *.elf
>
> echo ready to go?
> read dummy
>
> qemu-system-arm -M realview-pbx-a9 -m 128M -kernel t.bin \
> -serial mon:stdio -serial /dev/pts/0 -serial /dev/pts/0 -serial /dev/pts/0
>
> (where the number in /dev/pts/# is the number I get when I run ps in the terminal)
>
> The qemu terminal appears, but once I press 'Enter' again so that my code runs, I am faced with the unknown keycodes `(unnamed)', please report to qemu-devel@nongnu.org error message. After a couple of hours searching online I have not been able to find a solution and I have download and reinstalled qemu a couple of times.

Hi; this warning message (a) can usually be ignored and (b) doesn't
exist any more in new versions of QEMU. The chances are very high
that your problem is not related to the warning message. You might
also try using the latest version of QEMU (3.1).

Those -serial options look very weird. My guess is your problem
is either in those, or your guest binary simply is crashing
without sending anything to the terminal. Is the guest binary
known to work (eg on real hardware)?

thanks
-- PMM