[Qemu-devel] [5409] Reset CFI01 flash wcycle after erase confirm (Thomas Petazzoni).

[Qemu-devel] [5409] Reset CFI01 flash wcycle after erase confirm (Thomas Petazzoni).

[Andrzej Zaborowski]

Revision: 5409
          http://svn.sv.gnu.org/viewvc/?view=rev&root=qemu&revision=5409
Author:   balrog
Date:     2008-10-03 23:00:09 +0000 (Fri, 03 Oct 2008)

Log Message:
-----------
Reset CFI01 flash wcycle after erase confirm (Thomas Petazzoni).

pfl->wcycle was set to 1 when the erase confirm command was set, which
lead to the next command being misinterpreted by Qemu:

pflash_write: Unimplemented flash cmd sequence (offset 00000000,
wcycle 0x1 cmd 0x20 value 0x70)

This patch fixes this issue by resetting pfl->wcycle to 0 on erase
confirm so that the next command is considered as a new one.

Signed-off-by: Thomas Petazzoni <thomas.petazzoni@free-electrons.com>

Modified Paths:
--------------
    trunk/hw/pflash_cfi01.c

Modified: trunk/hw/pflash_cfi01.c
===================================================================
--- trunk/hw/pflash_cfi01.c	2008-10-03 19:04:42 UTC (rev 5408)
+++ trunk/hw/pflash_cfi01.c	2008-10-03 23:00:09 UTC (rev 5409)
@@ -267,7 +267,7 @@
         case 0x20: /* Block erase */
         case 0x28:
             if (cmd == 0xd0) { /* confirm */
-                pfl->wcycle = 1;
+                pfl->wcycle = 0;
                 pfl->status |= 0x80;
             } else if (cmd == 0xff) { /* read array mode */
                 goto reset_flash;