Re: Using parallel port on the Pegasos 2

[BALATON Zoltan <balaton@eik.bme.hu>]

On Sun, 28 Jul 2024, quan wrote:
> I am playing around with the parallel port on the pegasos 2 and I noticed
> the following issue:
> The parallel port on startup is set to iobase 0x378, then later it gets
> remapped to iobase 0x3bc.
> When I tried writing to the 0x3bc location with
> trace:memory_region_ops_write on, I get logs about writing to the location
> 'parallel', so far so good, but the writes don't make it through (it never
> calls parallel_ioport_write* functions)
>
> I traced it through where it calls portio_write, and inside the
> portio_write code:
> This line always fails for me:
> const MemoryRegionPortio *mrp = find_portio(mrpio, addr, size, true);
> This is due to the mrpio has the offset of 0x44 (0x3bc-0x378) in the list,
> and the 'addr' in the code ranges from (0-15) (address relative to 0x3bc),
> so it can never match the parallel io function to execute.
>
> This seems like a bug to me. I think there is some issue where the
> portio_list is not getting updated properly after the remapping to 0x3bc.
>
> The other devices (Serial, RTC, PM, VGA) responds properly for me, so it is
> only the parallel port that has this issue.

Is this something that broke recently or can the same be reproduced with 
QEMU v8.2.0. The relocation of these devices was implemented around commit 
35a6380b4ed27f (and the ones before that). Adding Bernhard to cc as well.

Regards,
BALATON Zoltan