Re: [Qemu-devel] [qemu-s390x] [PATCH-for-4.2 v1 1/6] s390x/mmu: ASC selection in s390_cpu_get_phys_page_debug()

[David Hildenbrand <david@redhat.com>]

On 12.08.19 17:28, David Hildenbrand wrote:
> On 12.08.19 17:18, Thomas Huth wrote:
>> On 8/12/19 1:27 PM, David Hildenbrand wrote:
>>> Let's select the ASC before calling the function. This is a prepararion
>>> to remove the ASC magic depending on the access mode from mmu_translate.
>>>
>>> There is currently no way to distinguish if we have code or data access.
>>> For now, we were using code access, because especially when debugging with
>>> the gdbstub, we want to read and disassemble what we single-step.
>>
>> IMHO we should add a "instruction" bit to MemTxAttrs and then use the
>> ...page_attrs_debug() interface instead. But ok, that's likely really
>> something for a separate clean-up, so for the time being:
>>
> 
> That sounds like a good idea, and then switching over to
> cc->get_phys_page_attrs()

But looking at get_phys_page_attrs_debug() again, "MemTxAttrs *attrs" is
an output value not an input value. So there wouldn't be a way to
specify "what you want" from the caller. At least unless I am missing
something :)

> 
> Thanks!
> 
>> Reviewed-by: Thomas Huth <thuth@redhat.com>
>>
> 
> 


-- 

Thanks,

David / dhildenb