* Patch "ARM: dts: fix the SD card on the Snowball" has been added to the 4.8-stable tree
@ 2016-11-08 16:46 gregkh
0 siblings, 0 replies; only message in thread
From: gregkh @ 2016-11-08 16:46 UTC (permalink / raw)
To: linus.walleij, daniel.lezcano, gregkh, olof, ulf.hansson
Cc: stable, stable-commits
This is a note to let you know that I've just added the patch titled
ARM: dts: fix the SD card on the Snowball
to the 4.8-stable tree which can be found at:
http://www.kernel.org/git/?p=linux/kernel/git/stable/stable-queue.git;a=summary
The filename of the patch is:
arm-dts-fix-the-sd-card-on-the-snowball.patch
and it can be found in the queue-4.8 subdirectory.
If you, or anyone else, feels it should not be added to the stable tree,
please let <stable@vger.kernel.org> know about it.
>From 1b283eea6228880b765bc40fe4e555416437ce58 Mon Sep 17 00:00:00 2001
From: Linus Walleij <linus.walleij@linaro.org>
Date: Fri, 7 Oct 2016 10:52:17 +0200
Subject: ARM: dts: fix the SD card on the Snowball
From: Linus Walleij <linus.walleij@linaro.org>
commit 1b283eea6228880b765bc40fe4e555416437ce58 upstream.
This fixes a very annoying regression on the Snowball SD card
that has been around for a while. It turns out that the device
tree does not configure the direction pins properly, nor sets
up the pins for the voltage converter properly at boot. Unless
all things are correctly set up, the feedback clock will not
work, and makes the driver spew messages in the console (but
it works, very slowly):
root@Ux500:/ mount /dev/mmcblk0p2 /mnt/
[ 9.953460] mmci-pl18x 80126000.sdi0_per1: error during DMA transfer!
[ 9.960296] mmcblk0: error -110 sending status command, retrying
[ 9.966461] mmcblk0: error -110 sending status command, retrying
[ 9.972534] mmcblk0: error -110 sending status command, aborting
Fix this by rectifying the device tree to correspond to that of
the Ux500 HREF boards plus the DAT31DIR setting that is unique for
the Snowball, and things start working smoothly. Add in the SDR12
and SDR25 modes which this host can do without any problems.
I don't know if this has ever been correct, sadly. It works after
this patch.
Reported-by: Daniel Lezcano <daniel.lezcano@linaro.org>
Cc: Ulf Hansson <ulf.hansson@linaro.org>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Olof Johansson <olof@lixom.net>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
---
arch/arm/boot/dts/ste-snowball.dts | 15 +++++++++++++--
1 file changed, 13 insertions(+), 2 deletions(-)
--- a/arch/arm/boot/dts/ste-snowball.dts
+++ b/arch/arm/boot/dts/ste-snowball.dts
@@ -239,14 +239,25 @@
arm,primecell-periphid = <0x10480180>;
max-frequency = <100000000>;
bus-width = <4>;
+ cap-sd-highspeed;
cap-mmc-highspeed;
+ sd-uhs-sdr12;
+ sd-uhs-sdr25;
+ /* All direction control is used */
+ st,sig-dir-cmd;
+ st,sig-dir-dat0;
+ st,sig-dir-dat2;
+ st,sig-dir-dat31;
+ st,sig-pin-fbclk;
+ full-pwr-cycle;
vmmc-supply = <&ab8500_ldo_aux3_reg>;
vqmmc-supply = <&vmmci>;
pinctrl-names = "default", "sleep";
pinctrl-0 = <&sdi0_default_mode>;
pinctrl-1 = <&sdi0_sleep_mode>;
- cd-gpios = <&gpio6 26 GPIO_ACTIVE_LOW>; // 218
+ /* GPIO218 MMC_CD */
+ cd-gpios = <&gpio6 26 GPIO_ACTIVE_LOW>;
status = "okay";
};
@@ -549,7 +560,7 @@
/* VMMCI level-shifter enable */
snowball_cfg3 {
pins = "GPIO217_AH12";
- ste,config = <&gpio_out_lo>;
+ ste,config = <&gpio_out_hi>;
};
/* VMMCI level-shifter voltage select */
snowball_cfg4 {
Patches currently in stable-queue which might be from linus.walleij@linaro.org are
queue-4.8/gpio-gpio_get_chipinfo_ioctl-fix-line-offset-validation.patch
queue-4.8/gpio-gpio_get_line-handle-event-_ioctl-fix-file-descriptor-leak.patch
queue-4.8/gpio-gpio_get_chipinfo_ioctl-fix-information-leak.patch
queue-4.8/gpio-gpio_get_lineevent_ioctl-reject-invalid-line-and-event-flags.patch
queue-4.8/gpio-gpiohandle_get_line_values_ioctl-fix-another-information-leak.patch
queue-4.8/gpio-acpi-fix-returned-error-from-acpi_dev_gpio_irq_get.patch
queue-4.8/gpio-gpio_get_linehandle_ioctl-reject-invalid-line-flags.patch
queue-4.8/gpio-gpio_get_lineevent_ioctl-validate-line-offset.patch
queue-4.8/arm-dts-fix-the-sd-card-on-the-snowball.patch
queue-4.8/gpio-gpiohandle_get_line_values_ioctl-fix-information-leak.patch
queue-4.8/gpio-gpio_get_linehandle_ioctl-validate-line-offset.patch
^ permalink raw reply [flat|nested] only message in thread
only message in thread, other threads:[~2016-11-08 16:46 UTC | newest]
Thread overview: (only message) (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2016-11-08 16:46 Patch "ARM: dts: fix the SD card on the Snowball" has been added to the 4.8-stable tree gregkh
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).