Patch "spi: sh-msiof: Avoid writing to registers from spi_master.setup()" has been added to the 4.15-stable tree

[<gregkh@linuxfoundation.org>]

This is a note to let you know that I've just added the patch titled

    spi: sh-msiof: Avoid writing to registers from spi_master.setup()

to the 4.15-stable tree which can be found at:
    http://www.kernel.org/git/?p=linux/kernel/git/stable/stable-queue.git;a=summary

The filename of the patch is:
     spi-sh-msiof-avoid-writing-to-registers-from-spi_master.setup.patch
and it can be found in the queue-4.15 subdirectory.

If you, or anyone else, feels it should not be added to the stable tree,
please let <stable@vger.kernel.org> know about it.


>From foo@baz Thu Mar 22 14:03:39 CET 2018
From: Geert Uytterhoeven <geert+renesas@glider.be>
Date: Wed, 13 Dec 2017 20:05:10 +0100
Subject: spi: sh-msiof: Avoid writing to registers from spi_master.setup()

From: Geert Uytterhoeven <geert+renesas@glider.be>


[ Upstream commit 7ff0b53c4051145d1cf992d2f60987e6447eed4f ]

The spi_master.setup() callback must not change configuration registers,
as that could corrupt I/O that is in progress for other SPI slaves.

The only exception is the configuration of the native chip select
polarity in SPI master mode, as a wrong chip select polarity will cause
havoc during all future transfers to any other SPI slave.

Hence stop writing to registers in sh_msiof_spi_setup(), unless it is
the first call for a controller using a native chip select, or unless
native chip select polarity has changed (note that you'll loose anyway
if I/O is in progress).  Even then, only do what is strictly necessary,
instead of calling sh_msiof_spi_set_pin_regs().

Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
Signed-off-by: Mark Brown <broonie@kernel.org>
Signed-off-by: Sasha Levin <alexander.levin@microsoft.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
---
 drivers/spi/spi-sh-msiof.c |   35 ++++++++++++++++++++++++-----------
 1 file changed, 24 insertions(+), 11 deletions(-)

--- a/drivers/spi/spi-sh-msiof.c
+++ b/drivers/spi/spi-sh-msiof.c
@@ -55,6 +55,8 @@ struct sh_msiof_spi_priv {
 	void *rx_dma_page;
 	dma_addr_t tx_dma_addr;
 	dma_addr_t rx_dma_addr;
+	bool native_cs_inited;
+	bool native_cs_high;
 	bool slave_aborted;
 };
 
@@ -528,8 +530,7 @@ static int sh_msiof_spi_setup(struct spi
 {
 	struct device_node	*np = spi->master->dev.of_node;
 	struct sh_msiof_spi_priv *p = spi_master_get_devdata(spi->master);
-
-	pm_runtime_get_sync(&p->pdev->dev);
+	u32 clr, set, tmp;
 
 	if (!np) {
 		/*
@@ -539,19 +540,31 @@ static int sh_msiof_spi_setup(struct spi
 		spi->cs_gpio = (uintptr_t)spi->controller_data;
 	}
 
-	/* Configure pins before deasserting CS */
-	sh_msiof_spi_set_pin_regs(p, !!(spi->mode & SPI_CPOL),
-				  !!(spi->mode & SPI_CPHA),
-				  !!(spi->mode & SPI_3WIRE),
-				  !!(spi->mode & SPI_LSB_FIRST),
-				  !!(spi->mode & SPI_CS_HIGH));
-
-	if (spi->cs_gpio >= 0)
+	if (spi->cs_gpio >= 0) {
 		gpio_set_value(spi->cs_gpio, !(spi->mode & SPI_CS_HIGH));
+		return 0;
+	}
+
+	if (spi_controller_is_slave(p->master))
+		return 0;
 
+	if (p->native_cs_inited &&
+	    (p->native_cs_high == !!(spi->mode & SPI_CS_HIGH)))
+		return 0;
 
+	/* Configure native chip select mode/polarity early */
+	clr = MDR1_SYNCMD_MASK;
+	set = MDR1_TRMD | TMDR1_PCON | MDR1_SYNCMD_SPI;
+	if (spi->mode & SPI_CS_HIGH)
+		clr |= BIT(MDR1_SYNCAC_SHIFT);
+	else
+		set |= BIT(MDR1_SYNCAC_SHIFT);
+	pm_runtime_get_sync(&p->pdev->dev);
+	tmp = sh_msiof_read(p, TMDR1) & ~clr;
+	sh_msiof_write(p, TMDR1, tmp | set);
 	pm_runtime_put(&p->pdev->dev);
-
+	p->native_cs_high = spi->mode & SPI_CS_HIGH;
+	p->native_cs_inited = true;
 	return 0;
 }
 


Patches currently in stable-queue which might be from geert+renesas@glider.be are

queue-4.15/spi-sh-msiof-avoid-writing-to-registers-from-spi_master.setup.patch
queue-4.15/pci-rcar-handle-rcar_pcie_parse_request_of_pci_ranges-failures.patch