FAILED: patch "[PATCH] mtd: rawnand: denali_dt: set clk_x_rate to 200 MHz" failed to apply to 4.14-stable tree

[<gregkh@linuxfoundation.org>]

The patch below does not apply to the 4.14-stable tree.
If someone wants it applied there, or to any other stable or longterm
tree, then please email the backport, including the original git commit
id to <stable@vger.kernel.org>.

thanks,

greg k-h

------------------ original commit in Linus's tree ------------------

>From 3f6e6986045d47f87bd982910821b7ab9758487e Mon Sep 17 00:00:00 2001
From: Masahiro Yamada <yamada.masahiro@socionext.com>
Date: Sat, 23 Jun 2018 01:06:34 +0900
Subject: [PATCH] mtd: rawnand: denali_dt: set clk_x_rate to 200 MHz
 unconditionally

Since commit 1bb88666775e ("mtd: nand: denali: handle timing parameters
by setup_data_interface()"), denali_dt.c gets the clock rate from the
clock driver.  The driver expects the frequency of the bus interface
clock, whereas the clock driver of SOCFPGA provides the core clock.
Thus, the setup_data_interface() hook calculates timing parameters
based on a wrong frequency.

To make it work without relying on the clock driver, hard-code the clock
frequency, 200MHz.  This is fine for existing DT of UniPhier, and also
fixes the issue of SOCFPGA because both platforms use 200 MHz for the
bus interface clock.

Fixes: 1bb88666775e ("mtd: nand: denali: handle timing parameters by setup_data_interface()")
Cc: linux-stable <stable@vger.kernel.org> #4.14+
Reported-by: Philipp Rosenberger <p.rosenberger@linutronix.de>
Suggested-by: Boris Brezillon <boris.brezillon@bootlin.com>
Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>
Tested-by: Richard Weinberger <richard@nod.at>
Signed-off-by: Boris Brezillon <boris.brezillon@bootlin.com>

diff --git a/drivers/mtd/nand/raw/denali_dt.c b/drivers/mtd/nand/raw/denali_dt.c
index cfd33e6ca77f..5869e90cc14b 100644
--- a/drivers/mtd/nand/raw/denali_dt.c
+++ b/drivers/mtd/nand/raw/denali_dt.c
@@ -123,7 +123,11 @@ static int denali_dt_probe(struct platform_device *pdev)
 	if (ret)
 		return ret;
 
-	denali->clk_x_rate = clk_get_rate(dt->clk);
+	/*
+	 * Hardcode the clock rate for the backward compatibility.
+	 * This works for both SOCFPGA and UniPhier.
+	 */
+	denali->clk_x_rate = 200000000;
 
 	ret = denali_init(denali);
 	if (ret)