From mboxrd@z Thu Jan 1 00:00:00 1970 Return-Path: From: Greg Kroah-Hartman To: linux-kernel@vger.kernel.org Cc: Greg Kroah-Hartman , stable@vger.kernel.org, Mika Westerberg , Wolfram Sang Subject: [ 3/5] i2c: designware: always clear interrupts before enabling them Date: Wed, 22 May 2013 15:18:09 -0700 Message-Id: <20130522221331.487538409@linuxfoundation.org> In-Reply-To: <20130522221330.720801923@linuxfoundation.org> References: <20130522221330.720801923@linuxfoundation.org> Sender: linux-kernel-owner@vger.kernel.org List-ID: 3.4-stable review patch. If anyone has any objections, please let me know. ------------------ From: Mika Westerberg commit 2a2d95e9d6d29e726cc294b65391917ed2e32bf4 upstream. If the I2C bus is put to a low power state by an ACPI method it might pull the SDA line low (as its power is removed). Once the bus is put to full power state again, the SDA line is pulled back to high. This transition looks like a STOP condition from the controller point-of-view which sets STOP detected bit in its status register causing the driver to fail subsequent transfers. Fix this by always clearing all interrupts before we start a transfer. Signed-off-by: Mika Westerberg Signed-off-by: Wolfram Sang Signed-off-by: Greg Kroah-Hartman --- drivers/i2c/busses/i2c-designware-core.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-) --- a/drivers/i2c/busses/i2c-designware-core.c +++ b/drivers/i2c/busses/i2c-designware-core.c @@ -349,7 +349,8 @@ static void i2c_dw_xfer_init(struct dw_i /* Enable the adapter */ dw_writel(dev, 1, DW_IC_ENABLE); - /* Enable interrupts */ + /* Clear and enable interrupts */ + i2c_dw_clear_int(dev); dw_writel(dev, DW_IC_INTR_DEFAULT_MASK, DW_IC_INTR_MASK); }