From: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
To: linux-kernel@vger.kernel.org
Cc: Greg Kroah-Hartman <gregkh@linuxfoundation.org>,
stable@vger.kernel.org,
Soeren Grunewald <soeren.grunewald@desy.de>
Subject: [PATCH 3.14 36/37] serial: 8250_pci: Add support for 12 port Exar boards
Date: Fri, 6 Nov 2015 11:24:51 -0800 [thread overview]
Message-ID: <20151106192413.098362306@linuxfoundation.org> (raw)
In-Reply-To: <20151106192410.681850286@linuxfoundation.org>
3.14-stable review patch. If anyone has any objections, please let me know.
------------------
From: Soeren Grunewald <soeren.grunewald@desy.de>
commit be32c0cf0462c36f482b5ddcff1d8371be1e183c upstream.
The Exar XR17V358 can also be combined with a XR17V354 chip to act as a
single 12 port chip. This works the same way as the combining two XR17V358
chips. But the reported device id then is 0x4358.
Signed-off-by: Soeren Grunewald <soeren.grunewald@desy.de>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
---
drivers/tty/serial/8250/8250_pci.c | 21 +++++++++++++++++++++
1 file changed, 21 insertions(+)
--- a/drivers/tty/serial/8250/8250_pci.c
+++ b/drivers/tty/serial/8250/8250_pci.c
@@ -1772,6 +1772,7 @@ pci_wch_ch353_setup(struct serial_privat
#define PCI_DEVICE_ID_SUNIX_1999 0x1999
+#define PCI_DEVICE_ID_EXAR_XR17V4358 0x4358
#define PCI_DEVICE_ID_EXAR_XR17V8358 0x8358
/* Unknown vendors/cards - this should not be in linux/pci_ids.h */
@@ -2270,6 +2271,13 @@ static struct pci_serial_quirk pci_seria
},
{
.vendor = PCI_VENDOR_ID_EXAR,
+ .device = PCI_DEVICE_ID_EXAR_XR17V4358,
+ .subvendor = PCI_ANY_ID,
+ .subdevice = PCI_ANY_ID,
+ .setup = pci_xr17v35x_setup,
+ },
+ {
+ .vendor = PCI_VENDOR_ID_EXAR,
.device = PCI_DEVICE_ID_EXAR_XR17V8358,
.subvendor = PCI_ANY_ID,
.subdevice = PCI_ANY_ID,
@@ -2715,6 +2723,7 @@ enum pci_board_num_t {
pbn_exar_XR17V352,
pbn_exar_XR17V354,
pbn_exar_XR17V358,
+ pbn_exar_XR17V4358,
pbn_exar_XR17V8358,
pbn_exar_ibm_saturn,
pbn_pasemi_1682M,
@@ -3385,6 +3394,14 @@ static struct pciserial_board pci_boards
.reg_shift = 0,
.first_offset = 0,
},
+ [pbn_exar_XR17V4358] = {
+ .flags = FL_BASE0,
+ .num_ports = 12,
+ .base_baud = 7812500,
+ .uart_offset = 0x400,
+ .reg_shift = 0,
+ .first_offset = 0,
+ },
[pbn_exar_XR17V8358] = {
.flags = FL_BASE0,
.num_ports = 16,
@@ -4763,6 +4780,10 @@ static struct pci_device_id serial_pci_t
PCI_ANY_ID, PCI_ANY_ID,
0,
0, pbn_exar_XR17V358 },
+ { PCI_VENDOR_ID_EXAR, PCI_DEVICE_ID_EXAR_XR17V4358,
+ PCI_ANY_ID, PCI_ANY_ID,
+ 0,
+ 0, pbn_exar_XR17V4358 },
{ PCI_VENDOR_ID_EXAR, PCI_DEVICE_ID_EXAR_XR17V8358,
PCI_ANY_ID, PCI_ANY_ID,
0,
next prev parent reply other threads:[~2015-11-06 19:24 UTC|newest]
Thread overview: 38+ messages / expand[flat|nested] mbox.gz Atom feed top
2015-11-06 19:24 [PATCH 3.14 00/37] 3.14.57-stable review Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 01/37] ath9k: declare required extra tx headroom Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 02/37] iwlwifi: dvm: fix D3 firmware PN programming Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 03/37] iwlwifi: fix firmware filename for 3160 Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 04/37] iwlwifi: mvm: fix D3 firmware PN programming Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 05/37] iwlwifi: pci: add a few more PCI subvendor IDs for the 7265 series Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 06/37] iommu/amd: Dont clear DTE flags when modifying it Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 07/37] powerpc/rtas: Validate rtas.entry before calling enter_rtas() Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 08/37] ASoC: wm8904: Correct number of EQ registers Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 09/37] x86/setup: Extend low identity map to cover whole kernel range Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 10/37] mm: make sendfile(2) killable Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 14/37] drm/nouveau/gem: return only valid domain when theres only one Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 16/37] drm/radeon: dont try to recreate sysfs entries on resume Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 18/37] rbd: require stable pages if message data CRCs are enabled Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 19/37] rbd: dont leak parent_spec in rbd_dev_probe_parent() Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 20/37] rbd: prevent kernel stack blow up on rbd map Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 21/37] Revert "ARM64: unwind: Fix PC calculation" Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 22/37] dm btree remove: fix a bug when rebalancing nodes after removal Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 23/37] dm btree: fix leak of bufio-backed block in btree_split_beneath error path Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 24/37] xhci: handle no ping response error properly Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 25/37] xhci: Add spurious wakeup quirk for LynxPoint-LP controllers Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 26/37] xen-blkfront: check for null drvdata in blkback_changed (XenbusStateClosing) Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 27/37] module: Fix locking in symbol_put_addr() Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 28/37] crypto: api - Only abort operations on fatal signal Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 29/37] md/raid1: submit_bio_wait() returns 0 on success Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 30/37] md/raid10: " Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 31/37] Revert "md: allow a partially recovered device to be hot-added to an array." Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 33/37] IB/cm: Fix rb-tree duplicate free and use-after-free Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 34/37] md/raid5: fix locking in handle_stripe_clean_event() Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 35/37] serial: 8250_pci: Add support for 16 port Exar boards Greg Kroah-Hartman
2015-11-23 14:23 ` Soeren Grunewald
2016-02-23 23:51 ` Greg Kroah-Hartman
2015-11-06 19:24 ` Greg Kroah-Hartman [this message]
2015-11-06 19:24 ` [PATCH 3.14 37/37] xen: fix backport of previous kexec patch Greg Kroah-Hartman
2015-11-07 1:41 ` [PATCH 3.14 00/37] 3.14.57-stable review Guenter Roeck
2015-11-07 2:54 ` Shuah Khan
[not found] ` <56402111.42371c0a.e127c.749b@mx.google.com>
2015-11-09 4:41 ` Kevin Hilman
2015-11-09 17:09 ` Greg Kroah-Hartman
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20151106192413.098362306@linuxfoundation.org \
--to=gregkh@linuxfoundation.org \
--cc=linux-kernel@vger.kernel.org \
--cc=soeren.grunewald@desy.de \
--cc=stable@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).