[PATCH 5.0 20/32] bnxt_en: Improve multicast address setup logic.

[Greg Kroah-Hartman <gregkh@linuxfoundation.org>]

From: Michael Chan <michael.chan@broadcom.com>

[ Upstream commit b4e30e8e7ea1d1e35ffd64ca46f7d9a7f227b4bf ]

The driver builds a list of multicast addresses and sends it to the
firmware when the driver's ndo_set_rx_mode() is called.  In rare
cases, the firmware can fail this call if internal resources to
add multicast addresses are exhausted.  In that case, we should
try the call again by setting the ALL_MCAST flag which is more
guaranteed to succeed.

Fixes: c0c050c58d84 ("bnxt_en: New Broadcom ethernet driver.")
Signed-off-by: Michael Chan <michael.chan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
---
 drivers/net/ethernet/broadcom/bnxt/bnxt.c |    9 ++++++++-
 1 file changed, 8 insertions(+), 1 deletion(-)

--- a/drivers/net/ethernet/broadcom/bnxt/bnxt.c
+++ b/drivers/net/ethernet/broadcom/bnxt/bnxt.c
@@ -8889,8 +8889,15 @@ static int bnxt_cfg_rx_mode(struct bnxt
 
 skip_uc:
 	rc = bnxt_hwrm_cfa_l2_set_rx_mask(bp, 0);
+	if (rc && vnic->mc_list_count) {
+		netdev_info(bp->dev, "Failed setting MC filters rc: %d, turning on ALL_MCAST mode\n",
+			    rc);
+		vnic->rx_mask |= CFA_L2_SET_RX_MASK_REQ_MASK_ALL_MCAST;
+		vnic->mc_list_count = 0;
+		rc = bnxt_hwrm_cfa_l2_set_rx_mask(bp, 0);
+	}
 	if (rc)
-		netdev_err(bp->dev, "HWRM cfa l2 rx mask failure rc: %x\n",
+		netdev_err(bp->dev, "HWRM cfa l2 rx mask failure rc: %d\n",
 			   rc);
 
 	return rc;