[PATCH 2/3] xhci: prevent bus suspend if a roothub port detected a over-current condition

[Mathias Nyman <mathias.nyman@linux.intel.com>]

Suspending the bus and host controller while a port is in a over-current
condition may halt the host.
Also keep the roothub running if over-current is active.

Cc: <stable@vger.kernel.org>
Signed-off-by: Mathias Nyman <mathias.nyman@linux.intel.com>
---
 drivers/usb/host/xhci-hub.c | 9 +++++++++
 1 file changed, 9 insertions(+)

diff --git a/drivers/usb/host/xhci-hub.c b/drivers/usb/host/xhci-hub.c
index 9eca1fe81061..f37316d2c8fa 100644
--- a/drivers/usb/host/xhci-hub.c
+++ b/drivers/usb/host/xhci-hub.c
@@ -1571,6 +1571,8 @@ int xhci_hub_status_data(struct usb_hcd *hcd, char *buf)
 		}
 		if ((temp & PORT_RC))
 			reset_change = true;
+		if (temp & PORT_OC)
+			status = 1;
 	}
 	if (!status && !reset_change) {
 		xhci_dbg(xhci, "%s: stopping port polling.\n", __func__);
@@ -1636,6 +1638,13 @@ int xhci_bus_suspend(struct usb_hcd *hcd)
 				 port_index);
 			goto retry;
 		}
+		/* bail out if port detected a over-current condition */
+		if (t1 & PORT_OC) {
+			bus_state->bus_suspended = 0;
+			spin_unlock_irqrestore(&xhci->lock, flags);
+			xhci_dbg(xhci, "Bus suspend bailout, port over-current detected\n");
+			return -EBUSY;
+		}
 		/* suspend ports in U0, or bail out for new connect changes */
 		if ((t1 & PORT_PE) && (t1 & PORT_PLS_MASK) == XDEV_U0) {
 			if ((t1 & PORT_CSC) && wake_enabled) {
-- 
2.17.1