From: Sasha Levin <sashal@kernel.org>
To: Roy Spliet <nouveau@spliet.org>
Cc: Takashi Iwai <tiwai@suse.de>,
alsa-devel@alsa-project.org, stable@vger.kernel.org
Subject: Re: [PATCH AUTOSEL 5.6 12/38] ALSA: hda: Skip controller resume if not needed
Date: Thu, 30 Apr 2020 21:17:24 -0400 [thread overview]
Message-ID: <20200501011724.GF13035@sasha-vm> (raw)
In-Reply-To: <f5f301c7-a74d-7c2e-d182-3f003bfc061b@spliet.org>
On Thu, Apr 30, 2020 at 11:36:05PM +0100, Roy Spliet wrote:
>(Minus "Linux kernel", that list has enough volume)
>
>Op 24-04-2020 om 13:44 schreef Takashi Iwai:
>>On Fri, 24 Apr 2020 14:22:10 +0200,
>>Sasha Levin wrote:
>>>
>>>From: Takashi Iwai <tiwai@suse.de>
>>>
>>>[ Upstream commit c4c8dd6ef807663e42a5f04ea77cd62029eb99fa ]
>>>
>>>The HD-audio controller does system-suspend and resume operations by
>>>directly calling its helpers __azx_runtime_suspend() and
>>>__azx_runtime_resume(). However, in general, we don't have to resume
>>>always the device fully at the system resume; typically, if a device
>>>has been runtime-suspended, we can leave it to runtime resume.
>>>
>>>Usually for achieving this, the driver would call
>>>pm_runtime_force_suspend() and pm_runtime_force_resume() pairs in the
>>>system suspend and resume ops. Unfortunately, this doesn't work for
>>>the resume path in our case. For handling the jack detection at the
>>>system resume, a child codec device may need the (literally) forcibly
>>>resume even if it's been runtime-suspended, and for that, the
>>>controller device must be also resumed even if it's been suspended.
>>>
>>>This patch is an attempt to improve the situation. It replaces the
>>>direct __azx_runtime_suspend()/_resume() calls with with
>>>pm_runtime_force_suspend() and pm_runtime_force_resume() with a slight
>>>trick as we've done for the codec side. More exactly:
>>>
>>>- azx_has_pm_runtime() check is dropped from azx_runtime_suspend() and
>>> azx_runtime_resume(), so that it can be properly executed from the
>>> system-suspend/resume path
>>>
>>>- The WAKEEN handling depends on the card's power state now; it's set
>>> and cleared only for the runtime-suspend
>>>
>>>- azx_resume() checks whether any codec may need the forcible resume
>>> beforehand. If the forcible resume is required, it does temporary
>>> PM refcount up/down for actually triggering the runtime resume.
>>>
>>>- A new helper function, hda_codec_need_resume(), is introduced for
>>> checking whether the codec needs a forcible runtime-resume, and the
>>> existing code is rewritten with that.
>>>
>>>BugLink: https://bugzilla.kernel.org/show_bug.cgi?id=207043
>>>Link: https://lore.kernel.org/r/20200413082034.25166-6-tiwai@suse.de
>>>Signed-off-by: Takashi Iwai <tiwai@suse.de>
>>>Signed-off-by: Sasha Levin <sashal@kernel.org>
>>
>>This commit is known to cause a regression, and the fix patch is
>>included in today's pull request. If we apply this, better to wait
>>for the next batch including its fix.
>
>These six patches, plus Takashi's fix on top of them, do not seem to
>have made it to 5.6.7 or 5.6.8 in the end. Is there a plan to include
AUTOSEL stuff take a while to hit the stable trees, if you want patches
in quicker they should be tagged for stable...
>them in 5.6.9?
What are the commit ids?
--
Thanks,
Sasha
next prev parent reply other threads:[~2020-05-01 1:17 UTC|newest]
Thread overview: 45+ messages / expand[flat|nested] mbox.gz Atom feed top
2020-04-24 12:21 [PATCH AUTOSEL 5.6 01/38] libbpf: Initialize *nl_pid so gcc 10 is happy Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 02/38] net: fec: set GPR bit on suspend by DT configuration Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 03/38] x86: hyperv: report value of misc_features Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 04/38] signal: check sig before setting info in kill_pid_usb_asyncio Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 05/38] hwmon: (drivetemp) Use drivetemp's true module name in Kconfig section Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 06/38] hwmon: (drivetemp) Return -ENODATA for invalid temperatures Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 07/38] afs: Fix length of dump of bad YFSFetchStatus record Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 08/38] xfs: acquire superblock freeze protection on eofblocks scans Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 09/38] xfs: fix partially uninitialized structure in xfs_reflink_remap_extent Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 10/38] ALSA: hda: Release resources at error in delayed probe Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 11/38] ALSA: hda: Keep the controller initialization even if no codecs found Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 12/38] ALSA: hda: Skip controller resume if not needed Sasha Levin
2020-04-24 12:44 ` Takashi Iwai
2020-04-30 22:36 ` Roy Spliet
2020-05-01 1:17 ` Sasha Levin [this message]
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 13/38] ALSA: hda: Explicitly permit using autosuspend if runtime PM is supported Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 14/38] drm/amdgpu: fix wrong vram lost counter increment V2 Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 15/38] scsi: target: fix PR IN / READ FULL STATUS for FC Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 16/38] scsi: target: tcmu: reset_ring should reset TCMU_DEV_BIT_BROKEN Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 17/38] clk: asm9260: fix __clk_hw_register_fixed_rate_with_accuracy typo Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 18/38] efi/x86: Don't remap text<->rodata gap read-only for mixed mode Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 19/38] objtool: Fix CONFIG_UBSAN_TRAP unreachable warnings Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 20/38] objtool: Support Clang non-section symbols in ORC dump Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 21/38] xen/xenbus: ensure xenbus_map_ring_valloc() returns proper grant status Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 22/38] ALSA: hda: call runtime_allow() for all hda controllers Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 23/38] net: stmmac: socfpga: Allow all RGMII modes Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 24/38] net/cxgb4: Check the return from t4_query_params properly Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 25/38] mac80211: fix channel switch trigger from unknown mesh peer Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 26/38] sched/isolation: Allow "isolcpus=" to skip unknown sub-parameters Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 27/38] sched/vtime: Work around an unitialized variable warning Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 28/38] i2c: remove i2c_new_probed_device API Sasha Levin
2020-04-24 13:36 ` Wolfram Sang
2020-04-25 1:51 ` Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 29/38] arm64: Delete the space separator in __emit_inst Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 30/38] i2c: tegra: Better handle case where CPU0 is busy for a long time Sasha Levin
2020-04-27 7:22 ` Thierry Reding
2020-05-01 0:59 ` Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 31/38] i2c: tegra: Synchronize DMA before termination Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 32/38] ext4: use matching invalidatepage in ext4_writepage Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 33/38] ext4: increase wait time needed before reuse of deleted inode numbers Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 34/38] ext4: convert BUG_ON's to WARN_ON's in mballoc.c Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 35/38] irqchip/gic-v4.1: Add support for VPENDBASER's Dirty+Valid signaling Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 36/38] blk-mq: Put driver tag in blk_mq_dispatch_rq_list() when no budget Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 37/38] irqchip/meson-gpio: Fix HARDIRQ-safe -> HARDIRQ-unsafe lock order Sasha Levin
2020-04-24 12:22 ` [PATCH AUTOSEL 5.6 38/38] hwmon: (jc42) Fix name to have no illegal characters Sasha Levin
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20200501011724.GF13035@sasha-vm \
--to=sashal@kernel.org \
--cc=alsa-devel@alsa-project.org \
--cc=nouveau@spliet.org \
--cc=stable@vger.kernel.org \
--cc=tiwai@suse.de \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).