Re: [REGRESSION][BISECTED] "xHCI host controller not responding, assume dead" on stable kernel > 6.8.7

[Mika Westerberg <mika.westerberg@linux.intel.com>]

On Tue, May 21, 2024 at 10:15:28AM +0200, Gia wrote:
> Here you go:
> 
> 0x0080 0x003c01c0 0b00000000 00111100 00000001 11000000 .... LANE_ADP_CS_0
>   [00:07]       0xc0 Next Capability Pointer
>   [08:15]        0x1 Capability ID
>   [16:19]        0xc Supported Link Speeds
>   [20:21]        0x3 Supported Link Widths (SLW)
>   [22:23]        0x0 Gen 4 Asymmetric Support (G4AS)
>   [26:26]        0x0 CL0s Support
>   [27:27]        0x0 CL1 Support
>   [28:28]        0x0 CL2 Support
> 0x0081 0x0828003c 0b00001000 00101000 00000000 00111100 .... LANE_ADP_CS_1
>   [00:03]        0xc Target Link Speed → Router shall attempt Gen 3 speed
>   [04:05]        0x3 Target Link Width → Establish a Symmetric Link
>   [06:07]        0x0 Target Asymmetric Link → Establish Symmetric Link
>   [10:10]        0x0 CL0s Enable
>   [11:11]        0x0 CL1 Enable
>   [12:12]        0x0 CL2 Enable
>   [14:14]        0x0 Lane Disable (LD)
>   [15:15]        0x0 Lane Bonding (LB)
>   [16:19]        0x8 Current Link Speed → Gen 2
>   [20:25]        0x2 Negotiated Link Width → Symmetric Link (x2)
>   [26:29]        0x2 Adapter State → CL0
>   [30:30]        0x0 PM Secondary (PMS)

Thanks this looks fine (although the link is still Gen 2). Can you run
the same from the dock upstream port too?

  # tbdump -r 2 -a 1 -vv -N2 LANE_ADP_CS_0