[PATCH v1 1/8] pinctrl: cy8c95x0: Don't miss reading the last bank registers

[Andy Shevchenko <andriy.shevchenko@linux.intel.com>]

When code had been changed to use for_each_set_clump8(), it mistakenly
switched from chip->nport to chip->tpin since the cy8c9540 and cy8c9560
have a 4-pin gap. This, in particular, led to the missed read of
the last bank interrupt status register and hence missing interrupts
on those pins. Restore the upper limit in for_each_set_clump8() to take
into consideration that gap.

Fixes: 83e29a7a1fdf ("pinctrl: cy8c95x0; Switch to use for_each_set_clump8()")
Cc: stable@vger.kernel.org
Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
---
 drivers/pinctrl/pinctrl-cy8c95x0.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/pinctrl/pinctrl-cy8c95x0.c b/drivers/pinctrl/pinctrl-cy8c95x0.c
index a4b04bf6d081..5c055d344ac9 100644
--- a/drivers/pinctrl/pinctrl-cy8c95x0.c
+++ b/drivers/pinctrl/pinctrl-cy8c95x0.c
@@ -627,7 +627,7 @@ static int cy8c95x0_write_regs_mask(struct cy8c95x0_pinctrl *chip, int reg,
 	bitmap_scatter(tmask, mask, chip->map, MAX_LINE);
 	bitmap_scatter(tval, val, chip->map, MAX_LINE);
 
-	for_each_set_clump8(offset, bits, tmask, chip->tpin) {
+	for_each_set_clump8(offset, bits, tmask, chip->nport * BANK_SZ) {
 		unsigned int i = offset / 8;
 
 		write_val = bitmap_get_value8(tval, offset);
@@ -655,7 +655,7 @@ static int cy8c95x0_read_regs_mask(struct cy8c95x0_pinctrl *chip, int reg,
 	bitmap_scatter(tmask, mask, chip->map, MAX_LINE);
 	bitmap_scatter(tval, val, chip->map, MAX_LINE);
 
-	for_each_set_clump8(offset, bits, tmask, chip->tpin) {
+	for_each_set_clump8(offset, bits, tmask, chip->nport * BANK_SZ) {
 		unsigned int i = offset / 8;
 
 		ret = cy8c95x0_regmap_read_bits(chip, reg, i, bits, &read_val);
-- 
2.50.1