[PATCH] hwmon: (corsair-psu) Close HID device on probe errors

[Myeonghun Pak <mhun512@gmail.com>]

corsairpsu_probe() opens the HID device before sending the device init
and firmware-info commands. If either command fails, the error path jumps
directly to fail_and_stop and skips hid_hw_close().

Use the existing fail_and_close label for those post-open failures so the
open count and low-level close callback are balanced before hid_hw_stop().

Fixes: d115b51e0e56 ("hwmon: add Corsair PSU HID controller driver")
Cc: stable@vger.kernel.org
Signed-off-by: Myeonghun Pak <mhun512@gmail.com>
---
 drivers/hwmon/corsair-psu.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/hwmon/corsair-psu.c b/drivers/hwmon/corsair-psu.c
index dddbd2463f..76f3e1da68 100644
--- a/drivers/hwmon/corsair-psu.c
+++ b/drivers/hwmon/corsair-psu.c
@@ -796,13 +796,13 @@ static int corsairpsu_probe(struct hid_device *hdev, const struct hid_device_id
 	ret = corsairpsu_init(priv);
 	if (ret < 0) {
 		dev_err(&hdev->dev, "unable to initialize device (%d)\n", ret);
-		goto fail_and_stop;
+		goto fail_and_close;
 	}
 
 	ret = corsairpsu_fwinfo(priv);
 	if (ret < 0) {
 		dev_err(&hdev->dev, "unable to query firmware (%d)\n", ret);
-		goto fail_and_stop;
+		goto fail_and_close;
 	}
 
 	corsairpsu_get_criticals(priv);
-- 
2.50.1