From: <gregkh@linuxfoundation.org>
To: kmehltretter@gmail.com,Frank.Li@nxp.com,gregkh@linuxfoundation.org,sashiko-bot@kernel.org
Cc: <stable@vger.kernel.org>
Subject: FAILED: patch "[PATCH] serial: imx: serialize imx_uart_ports[] lifetime" failed to apply to 5.10-stable tree
Date: Thu, 03 Sep 2026 14:38:33 +0200 [thread overview]
Message-ID: <2026090333-applause-active-107a@gregkh> (raw)
The patch below does not apply to the 5.10-stable tree.
If someone wants it applied there, or to any other stable or longterm
tree, then please email the backport, including the original git commit
id to <stable@vger.kernel.org>.
To reproduce the conflict and resubmit, you may use the following commands:
git fetch https://git.kernel.org/pub/scm/linux/kernel/git/stable/linux.git/ linux-5.10.y
git checkout FETCH_HEAD
git cherry-pick -x 8b0b29fdcb47907ae0296b8fe829e918e05e300f
# <resolve conflicts, build, test, etc.>
git commit -s
git send-email --to '<stable@vger.kernel.org>' --in-reply-to '2026090333-applause-active-107a@gregkh' --subject-prefix 'PATCH 5.10.y' 'HEAD^..'
Possible dependencies:
thanks,
greg k-h
------------------ original commit in Linus's tree ------------------
From 8b0b29fdcb47907ae0296b8fe829e918e05e300f Mon Sep 17 00:00:00 2001
From: Karl Mehltretter <kmehltretter@gmail.com>
Date: Fri, 31 Jul 2026 20:18:44 +0200
Subject: [PATCH] serial: imx: serialize imx_uart_ports[] lifetime
imx_uart_probe() publishes its devm-allocated port in imx_uart_ports[]
before uart_add_one_port() because console setup uses the table. The entry
is not cleared when adding the port fails or after removal, leaving a
dangling pointer.
A sibling probe can register the shared console through that stale entry.
This was reproduced under KASAN on QEMU mcimx6ul-evk by unbinding a
sibling UART, unbinding the console UART and rebinding the sibling.
Keep the entry valid through uart_remove_one_port(), then clear it. Protect
port addition and removal together with their table updates so sibling
operations cannot interleave. Reject an occupied slot rather than
clobbering an active port during a duplicate-line probe.
Fixes: dbff4e9ea2e8 ("IMX UART: remove statically initialized tables")
Fixes: 9f322ad064f9 ("imx: serial: handle initialisation failure correctly")
Reported-by: Sashiko <sashiko-bot@kernel.org>
Link: https://lore.kernel.org/all/20260719162850.043B41F000E9@smtp.kernel.org
Link: https://lore.kernel.org/all/20260719222501.CB4CB1F000E9@smtp.kernel.org
Cc: stable@vger.kernel.org
Assisted-by: Claude:claude-fable-5
Signed-off-by: Karl Mehltretter <kmehltretter@gmail.com>
Reviewed-by: Frank Li <Frank.Li@nxp.com>
Link: https://patch.msgid.link/20260731181844.11330-6-kmehltretter@gmail.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/tty/serial/imx.c b/drivers/tty/serial/imx.c
index 95fdb60e06a7..513dbe95f7e9 100644
--- a/drivers/tty/serial/imx.c
+++ b/drivers/tty/serial/imx.c
@@ -22,6 +22,7 @@
#include <linux/clk.h>
#include <linux/delay.h>
#include <linux/ktime.h>
+#include <linux/mutex.h>
#include <linux/pinctrl/consumer.h>
#include <linux/rational.h>
#include <linux/slab.h>
@@ -2080,6 +2081,9 @@ static const struct uart_ops imx_uart_pops = {
static struct imx_port *imx_uart_ports[UART_NR];
+/* Held across uart_add/remove_one_port(); console callbacks must not take it. */
+static DEFINE_MUTEX(imx_uart_ports_lock);
+
#if IS_ENABLED(CONFIG_SERIAL_IMX_CONSOLE)
static void imx_uart_console_putchar(struct uart_port *port, unsigned char ch)
{
@@ -2621,11 +2625,19 @@ static int imx_uart_probe(struct platform_device *pdev)
goto err_clk;
}
- imx_uart_ports[sport->port.line] = sport;
-
platform_set_drvdata(pdev, sport);
- ret = uart_add_one_port(&imx_uart_uart_driver, &sport->port);
+ scoped_guard(mutex, &imx_uart_ports_lock) {
+ if (imx_uart_ports[sport->port.line]) {
+ ret = -EBUSY;
+ } else {
+ imx_uart_ports[sport->port.line] = sport;
+ ret = uart_add_one_port(&imx_uart_uart_driver,
+ &sport->port);
+ if (ret)
+ imx_uart_ports[sport->port.line] = NULL;
+ }
+ }
err_clk:
clk_disable_unprepare(sport->clk_ipg);
@@ -2637,7 +2649,9 @@ static void imx_uart_remove(struct platform_device *pdev)
{
struct imx_port *sport = platform_get_drvdata(pdev);
+ guard(mutex)(&imx_uart_ports_lock);
uart_remove_one_port(&imx_uart_uart_driver, &sport->port);
+ imx_uart_ports[sport->port.line] = NULL;
}
static void imx_uart_restore_context(struct imx_port *sport)
next reply other threads:[~2026-09-03 12:54 UTC|newest]
Thread overview: 3+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-09-03 12:38 gregkh [this message]
2026-09-04 14:23 ` [PATCH 5.10.y 1/2] serial: imx: Convert to platform remove callback returning void Sasha Levin
2026-09-04 14:23 ` [PATCH 5.10.y 2/2] serial: imx: serialize imx_uart_ports[] lifetime Sasha Levin
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=2026090333-applause-active-107a@gregkh \
--to=gregkh@linuxfoundation.org \
--cc=Frank.Li@nxp.com \
--cc=kmehltretter@gmail.com \
--cc=sashiko-bot@kernel.org \
--cc=stable@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox