FAILED: patch "[PATCH] Input: s6sy761 - fix resume ordering and restore sensing" failed to apply to 5.15-stable tree

[<gregkh@linuxfoundation.org>]

The patch below does not apply to the 5.15-stable tree.
If someone wants it applied there, or to any other stable or longterm
tree, then please email the backport, including the original git commit
id to <stable@vger.kernel.org>.

To reproduce the conflict and resubmit, you may use the following commands:

git fetch https://git.kernel.org/pub/scm/linux/kernel/git/stable/linux.git/ linux-5.15.y
git checkout FETCH_HEAD
git cherry-pick -x a215720959c5450b3699e243904b39c3f8f68888
# <resolve conflicts, build, test, etc.>
git commit -s
git send-email --to '<stable@vger.kernel.org>' --in-reply-to '2026100513-squatting-hankie-9c73@gregkh' --subject-prefix 'PATCH 5.15.y' 'HEAD^..'

Possible dependencies:



thanks,

greg k-h

------------------ original commit in Linus's tree ------------------

From a215720959c5450b3699e243904b39c3f8f68888 Mon Sep 17 00:00:00 2001
From: David Heidelberg <david@ixit.cz>
Date: Sat, 26 Sep 2026 22:26:47 +0200
Subject: [PATCH] Input: s6sy761 - fix resume ordering and restore sensing

System suspend powers the controller off and resume powers it back on,
but the resume path enables the interrupt before s6sy761_power_on()
checks the boot. The firmware raises its boot-complete event on the
interrupt line, the threaded handler consumes it, s6sy761_power_on()
then reads an empty event and resume fails with -ENODEV, skipping the
touch function setup:

s6sy761 2-0048: PM: dpm_run_callback(): s6sy761_resume [s6sy761] returns -19

Power the chip on first and only then unmask the interrupt. Once resume
completes the boot handshake the chip comes back with sensing off, as
at probe where input_open() turns it on, so the touchscreen stays dead
after resume. Send SENSE_ON again when the input device is open.

Tested on a Pixel 3 XL over several s2idle cycles: resume succeeds and
the touch function and sense status match the pre-suspend state.

Assisted-by: LLM
Cc: stable@vger.kernel.org
Fixes: 0145a7141e59 ("Input: add support for the Samsung S6SY761 touchscreen")
Signed-off-by: David Heidelberg <david@ixit.cz>
Link: https://patch.msgid.link/20260926-s6sy761-suspend-v2-1-8f00a96ee6e8@ixit.cz
Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>

diff --git a/drivers/input/touchscreen/s6sy761.c b/drivers/input/touchscreen/s6sy761.c
index 0f24a9b73063..899c179fb2d3 100644
--- a/drivers/input/touchscreen/s6sy761.c
+++ b/drivers/input/touchscreen/s6sy761.c
@@ -500,10 +500,22 @@ static int s6sy761_suspend(struct device *dev)
 static int s6sy761_resume(struct device *dev)
 {
 	struct s6sy761_data *sdata = dev_get_drvdata(dev);
+	int err;
+
+	err = s6sy761_power_on(sdata);
+	if (err)
+		return err;
 
 	enable_irq(sdata->client->irq);
 
-	return s6sy761_power_on(sdata);
+	guard(mutex)(&sdata->input->mutex);
+
+	if (!input_device_enabled(sdata->input))
+		return 0;
+
+	err = i2c_smbus_write_byte(sdata->client, S6SY761_SENSE_ON);
+
+	return err;
 }
 
 static const struct dev_pm_ops s6sy761_pm_ops = {