Re: Regression found (Stop-marking-clocks-as-CLK_IS_CRITICAL)

Hans de Goede
2018-10-30T16:02:00Z

Hi,

On 30-10-18 16:46, Hans de Goede wrote:
> Hi,
>
> On 30-10-18 16:04, Pierre-Louis Bossart wrote:
>>
>> On 10/30/18 9:38 AM, Dean Wallace wrote:
>>> On 30-10-18, Hans de Goede wrote:
>>>> Hi Dean,
>>>>
>>>> Attached are 2 different attempts at fixing this.
>>>>
>>>> When trying these patches do not forget to remove the revert of the
>>>> "Stop-marking-clocks-as-CLK_IS_CRITICAL" commit.
>>>>
>>>> Please first try the 0001-ASoC-intel-cht_bsw_max98090_ti-Use-pmc_plt_clk_0-ins.patch
>>>> patch I expect that one to do the trick indicating that the Swanky model
>>>> uses a different pmc clk then which is normally used for the codec clock.
>>>>
>>>> If that patch does not fix things, please give the other patch a try.
>>
>> For Baytrail devices, the audio platform clocks are not managed by the firmware. They are for CHT-based devices - as can be seen by clock resources being described in the DSDT. We used to have a if(baytrail) in the code which was replaced by this CRITICAL label, but the point remains that there is a difference between the two SOC versions.
>
> As I mentioned before the CRITICAL flag was only added a year ago to workaround
> an issue with on board ethernet needing plt_clk_4 on some laptops, this never
> had anything to do with sound.

Ah I see now that you later made some changes based on the patch to fix the ethernet:

https://git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git/commit?id=7735bce05a9c0bb0eb0f08c9002d65843a7c5798

Note though that that does not touch the machine driver which we are discussing
now and the reporters machine is also BYT based.

As explained below (in my original reply) I think it is fine to always
manage the clk from within the kernel. But if you think this is a bad
idea, we could re-introduce the is_valleyview() checks in machine
drivers which are used on CHT devices.

>> In addition I am not aware of any baytrail device using plt_clk_0, so moving a common machine driver such a cht_bsw_max98090_ti to use plt_clk0 only would break other devices (e.g. Rambi/Orco). Asking for both clocks to be on might work though,
>
> Ok, so we need to have a DMI based quirk for the Swanky and maybe also
> the clapper to use plt_clk_0 there. Asking for 2 clks if we only need
> one does not seem like a good plan.
>
>> however you still have the problem of trying to manage from the kernel what the firmware already manages.
>
> The firmware only manages it when going to D3 state, with ASoC most of
> the codecs gets turned off (and we no longer need the clock) but we do
> not put the device in D3 / execute the _PS3 method. So from a pm pov
> it is better if we manage the clk ourselves.
>
> Once we do actually put the device in D3 (on suspend) the kernel will have
> already turned off the clk and the _OFF method of the CLK3 power resource
> which directly pokes mmio, will just set the enable bit to 0 when it
> already is 0, so no problem.

Regards,

Hans