[U-Boot-Users] Problem about Image Linux-2.4.25 running on Lite5200

xueming
2004-11-27T03:39:53Z

Hello Wolfgang,
Sorry for bothering your again.
I burn Uboot to Lite5200 board, and build the Linux-2-4.25 with
following steps:

1) make mrproper
2) make icecube_5200_config
3) make oldconfig
4) make dep
5) make uImage
6) cp uImage to /tftp/MPC5200.
Then I download and run kernel as following :
1) tftp
2) bootm
After this, the linux kernel stop at the following lines:
//////////////////////////////////////////////////////
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 4096 bind 8192)
eth0: config: auto-negotiation off, 100FDX, 100HDX, 10FDX, 10HDX.
eth0: Waiting for the link to be up...
eth0: status: link up, 10 Mbps Half Duplex, auto-negotiation
complete.
IP-Config: Complete:
device=eth0, addr=222.28.219.55, mask=255.255.254.0,
gw=222.28.218.1,
host=icecube, domain=, nis-domain=(none),
bootserver=222.28.219.18, rootserver=222.28.219.18, rootpath=
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
Looking up port of RPC 100003/2 on 222.28.219.18
Looking up port of RPC 100005/1 on 222.28.219.18
VFS: Mounted root (nfs filesystem).
Freeing unused kernel memory: 76k init
Warning: unable to open an initial console.
========(Message Stop here .........)======
////////////////////////////////////////////

Could you give me some tips about how to solve the situation,thanks.

Best Regards,
Xueming, zhang