From mboxrd@z Thu Jan 1 00:00:00 1970 From: Ricky Date: Thu, 23 Jun 2005 16:53:33 +0530 Subject: [U-Boot-Users] Jump location Message-ID: <003701c577e5$fd510a50$3000a8c0@rakesh> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Hi List, I have a confusion with Jump address. In case of MPC processor, I have reset vector at 0xffffffc which is mention is "board//u-boot.lds" script file. If we edit the binary file we used to get Jump instruction ..in my case its "4b ff f0 04" what exactly it means how it will jump to the location FFFFF000...I have seen this address in u-boot.lds script file. Can anyone put some commnet on this. Thanks & Regards, Ricky -- This message contains information from GDA Technologies LTD and affiliates, and is intended for the sole use of the individual and entity to whom it is addressed. It may contain information, including any attachments, that is privileged, confidential and exempt from disclosure under applicable law. If you are not the intended addressee, nor authorized to receive for the intended addressee, you are hereby notified that you may not use, copy, disclose or distribute to anyone the message or any information contained in the message. If you have received this electronic transmission in error, please notify the sender immediately by a "reply to sender only" message and destroy all electronic and hard copies of the communication, including attachments. This message was scanned for spam and viruses by BitDefender.