[U-Boot-Users] [PATCH] mpc83xx: Revise the MPC8360EMDS readme doc

[Dave Liu <r63238@freescale.com>]

Sorry, please ignore this!

On Mon, 2007-06-25 at 10:40 +0800, Dave Liu wrote:
> From: Dave Liu <daveliu@freescale.com>
> 
> When the rev2.x silicon mount the MPC8360EMDS board, and
> if you are using the u-boot version after 2 Mar, 2007, to
> make the ethernet interface usable, we have to setup the
> jumpers correctly.
> 
> Signed-off-by: Dave Liu <daveliu@freescale.com>
> Signed-off-by: Kim Phillips <kim.phillips@freescale.com>
> ---
>  doc/README.mpc8360emds |   25 ++++++++++++++++++++++++-
>  1 files changed, 24 insertions(+), 1 deletions(-)
> 
> diff --git a/doc/README.mpc8360emds b/doc/README.mpc8360emds
> index c87469f..f898d02 100644
> --- a/doc/README.mpc8360emds
> +++ b/doc/README.mpc8360emds
> @@ -21,7 +21,13 @@ Freescale MPC8360EMDS Board
>  	SW3[1:8]= 0000_0001 refers to bits labeled 1 through 6 is set as "On"
>  		and bits labeled 8 is set as "Off".
>  
> -1.1	For the MPC8360E PB PROTO Board
> +1.1	There are three type boards for MPC8360E silicon up to now, They are
> +
> +	* MPC8360E-MDS-PB PROTO (a.k.a 8360SYS PROTOTYPE)
> +	* MPC8360E-MDS-PB PILOT (a.k.a 8360SYS PILOT)
> +	* MPC8360EA-MDS-PB PROTO (a.k.a 8360SYS2 PROTOTYPE)
> +
> +1.2	For all the MPC8360EMDS Board
>  
>  	First, make sure the board default setting is consistent with the
>  	document shipped with your board. Then apply the following setting:
> @@ -33,6 +39,23 @@ Freescale MPC8360EMDS Board
>  	JP6 1-2
>  	on board Oscillator: 66M
>  
> +1.3	Since different board/chip rev. combinations have AC timing issues,
> +	u-boot forces RGMII-ID (RGMII with Internal Delay) mode on by default
> +	by the patch as below:
> +
> +	[2007-03-02 mpc83xx: Disable G1TXCLK, G2TXCLK h/w buffers]
> +
> +	When the rev2.x silicon mount on these boards, and if you are using
> +	u-boot version after this patch, to make the ethernet interfaces usable,
> +	and to enable RGMII-ID on your board, you have to setup the jumpers
> +	correctly.
> +
> +	* MPC8360E-MDS-PB PROTO
> +	  nothing to do
> +	* MPC8360E-MDS-PB PILOT
> +	  JP9 and JP8 should be ON
> +	* MPC8360EA-MDS-PB PROTO
> +	  JP2 and JP3 should be ON
>  
>  2.	Memory Map
>