From mboxrd@z Thu Jan 1 00:00:00 1970 From: Dave Liu Date: Mon, 25 Jun 2007 12:57:41 +0800 Subject: [U-Boot-Users] [PATCH] mpc83xx: Revise the MPC8360EMDS readme doc In-Reply-To: <1182739202.3681.3.camel@localhost.localdomain> References: <1182739202.3681.3.camel@localhost.localdomain> Message-ID: <1182747461.3662.0.camel@localhost.localdomain> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Sorry, please ignore this! On Mon, 2007-06-25 at 10:40 +0800, Dave Liu wrote: > From: Dave Liu > > When the rev2.x silicon mount the MPC8360EMDS board, and > if you are using the u-boot version after 2 Mar, 2007, to > make the ethernet interface usable, we have to setup the > jumpers correctly. > > Signed-off-by: Dave Liu > Signed-off-by: Kim Phillips > --- > doc/README.mpc8360emds | 25 ++++++++++++++++++++++++- > 1 files changed, 24 insertions(+), 1 deletions(-) > > diff --git a/doc/README.mpc8360emds b/doc/README.mpc8360emds > index c87469f..f898d02 100644 > --- a/doc/README.mpc8360emds > +++ b/doc/README.mpc8360emds > @@ -21,7 +21,13 @@ Freescale MPC8360EMDS Board > SW3[1:8]= 0000_0001 refers to bits labeled 1 through 6 is set as "On" > and bits labeled 8 is set as "Off". > > -1.1 For the MPC8360E PB PROTO Board > +1.1 There are three type boards for MPC8360E silicon up to now, They are > + > + * MPC8360E-MDS-PB PROTO (a.k.a 8360SYS PROTOTYPE) > + * MPC8360E-MDS-PB PILOT (a.k.a 8360SYS PILOT) > + * MPC8360EA-MDS-PB PROTO (a.k.a 8360SYS2 PROTOTYPE) > + > +1.2 For all the MPC8360EMDS Board > > First, make sure the board default setting is consistent with the > document shipped with your board. Then apply the following setting: > @@ -33,6 +39,23 @@ Freescale MPC8360EMDS Board > JP6 1-2 > on board Oscillator: 66M > > +1.3 Since different board/chip rev. combinations have AC timing issues, > + u-boot forces RGMII-ID (RGMII with Internal Delay) mode on by default > + by the patch as below: > + > + [2007-03-02 mpc83xx: Disable G1TXCLK, G2TXCLK h/w buffers] > + > + When the rev2.x silicon mount on these boards, and if you are using > + u-boot version after this patch, to make the ethernet interfaces usable, > + and to enable RGMII-ID on your board, you have to setup the jumpers > + correctly. > + > + * MPC8360E-MDS-PB PROTO > + nothing to do > + * MPC8360E-MDS-PB PILOT > + JP9 and JP8 should be ON > + * MPC8360EA-MDS-PB PROTO > + JP2 and JP3 should be ON > > 2. Memory Map >