[U-Boot-Users] [PATCH] mpc83xx: UEC: add support for Broadcom BCM5481 Gigabit PHY

[Peter Barada <peterb@logicpd.com>]

On Tue, 2008-01-08 at 14:29 -0600, Kim Phillips wrote:
> On Tue, 8 Jan 2008 21:41:09 +0300
> Anton Vorontsov <avorontsov@ru.mvista.com> wrote:
> 
> > On Tue, Jan 08, 2008 at 10:50:18AM -0600, Kim Phillips wrote:
> > > On Tue, 25 Dec 2007 20:01:26 +0300
> > > Anton Vorontsov <avorontsov@ru.mvista.com> wrote:
> > > 
> > > > This patch adds basic support for Broadcom BCM5481 PHY,
> > > > with the quirk needed for at least MPC8360E-RDK.
> > > 
> > > ?  the MPC8360E-RDK doesn't exist in the mainline tree.
> > 
> > Patch for the board support was sent at the same time. Though,
> > I'll resend it with few improvements.
> 
> ok, yes, I'm a bit behind in my emails still :(.
> 
> I took a brief look at it; while modding, can you please:
> 
> a. reorder your Makefile entry in alpha order (per WD), and add
> MAINTAINERS and MAKEALL entries.
> 
> b. move the non-board specific nand code out of the board directory and
> merge with drivers/mtd/nand (this should go through Stefan Roese).
> 
> c. turn off CONFIG_OF_HAS_BD_T and CONFIG_OF_HAS_UBOOT_ENV (unless you
> have a really good reason to keep them on).
> 
> d. remove references to OF_CPU, OF_SOC, OF_QE, OF_TBCLK, OF_STDOUT_PATH
> and use the new libfdt glue code.
> 
> thanks in advance.
> 
> > > > Quirk comes from MPC8360E-RDK BSP source, I think author is
> > > > Peter Barada <peterb@logicpd.com>, but I'm not sure.
> > > 
> > > solicit his signoff then?
> > 
> > Not an absolute necessity.
> > 
> ok, we'll see if Peter replies anyway.  Thanks for paying attention to
> this matter.

I the code to the Freescale BSP u-boot-1.1.3 code that added support for
the 8360EPB board.  Where is the patch you put together so I can look it
over?

> 
> Kim
-- 
Peter Barada <peterb@logicpd.com>