[U-Boot] [PATCH 2/2] Some changes of TLB entry setting for MPC8572DS

[Haiying Wang <Haiying.Wang@freescale.com>]

- Move the TLB entry of PIXIS_BASE from TLB0 to TLB1[8], because in CAMP mode,
all the TLB0 entries will be invalidated after cpu1 brings up kernel, thus cpu0
can not access PIXIS_BASE anymore (any access will cause DataTLBError exception)

- Set CONFIG_SYS_DDR_TLB_START to 9 for MPC8572DS board.

Signed-off-by: Haiying Wang <Haiying.Wang@freescale.com>
---
 board/freescale/mpc8572ds/tlb.c |    9 +++++----
 include/configs/MPC8572DS.h     |    1 +
 2 files changed, 6 insertions(+), 4 deletions(-)

diff --git a/board/freescale/mpc8572ds/tlb.c b/board/freescale/mpc8572ds/tlb.c
index 2537b94..4f52d34 100644
--- a/board/freescale/mpc8572ds/tlb.c
+++ b/board/freescale/mpc8572ds/tlb.c
@@ -41,10 +41,6 @@ struct fsl_e_tlb_entry tlb_table[] = {
 		      MAS3_SX|MAS3_SW|MAS3_SR, 0,
 		      0, 0, BOOKE_PAGESZ_4K, 0),
 
-	SET_TLB_ENTRY(0, PIXIS_BASE, PIXIS_BASE_PHYS,
-		      MAS3_SX|MAS3_SW|MAS3_SR, MAS2_I|MAS2_G,
-		      0, 0, BOOKE_PAGESZ_4K, 0),
-
 	/* TLB 1 */
 	/* *I*** - Covers boot page */
 	SET_TLB_ENTRY(1, 0xfffff000, 0xfffff000,
@@ -86,6 +82,11 @@ struct fsl_e_tlb_entry tlb_table[] = {
 		      MAS3_SX|MAS3_SW|MAS3_SR, MAS2_I|MAS2_G,
 		      0, 7, BOOKE_PAGESZ_1M, 1),
 
+	/* *I*G - PIXIS_BASE */
+	SET_TLB_ENTRY(1, PIXIS_BASE, PIXIS_BASE_PHYS,
+		      MAS3_SX|MAS3_SW|MAS3_SR, MAS2_I|MAS2_G,
+		      0, 8, BOOKE_PAGESZ_4K, 1),
+
 };
 
 int num_tlb_entries = ARRAY_SIZE(tlb_table);
diff --git a/include/configs/MPC8572DS.h b/include/configs/MPC8572DS.h
index daf17a2..5d71ff8 100644
--- a/include/configs/MPC8572DS.h
+++ b/include/configs/MPC8572DS.h
@@ -93,6 +93,7 @@ extern unsigned long get_board_ddr_clk(unsigned long dummy);
 #define CONFIG_SYS_PCIE1_ADDR		(CONFIG_SYS_CCSRBAR+0xa000)
 
 /* DDR Setup */
+#define CONFIG_SYS_DDR_TLB_START	9
 #define CONFIG_FSL_DDR2
 #undef CONFIG_FSL_DDR_INTERACTIVE
 #ifndef CONFIG_NAND_U_BOOT
-- 
1.6.0.2