[U-Boot] [PATCH v3] MPC8349ITX: several config issues fixed

[Valeriy Glushkov <gvv@lstec.com>]

The previous version rebooted forever with DDR bigger than 256MB.
Access the DS1339 RTC chip is on I2C1 bus.
Allow DHCP.

Signed-off-by: Valeriy Glushkov <gvv@lstec.com>
---
 include/configs/MPC8349ITX.h |    5 +++++
 1 files changed, 5 insertions(+), 0 deletions(-)

diff --git a/include/configs/MPC8349ITX.h b/include/configs/MPC8349ITX.h
index 14cbc45..f1b5566 100644
--- a/include/configs/MPC8349ITX.h
+++ b/include/configs/MPC8349ITX.h
@@ -98,6 +98,7 @@
 #define CONFIG_SYS_I2C_OFFSET		0x3000
 #define CONFIG_SYS_I2C2_OFFSET		0x3100
 #define CONFIG_SYS_SPD_BUS_NUM		1	/* The I2C bus for SPD */
+#define CONFIG_SYS_RTC_BUS_NUM		1	/* The I2C bus for RTC */
 
 #define CONFIG_SYS_I2C_8574_ADDR1	0x20	/* I2C1, PCF8574 */
 #define CONFIG_SYS_I2C_8574_ADDR2	0x21	/* I2C1, PCF8574 */
@@ -158,6 +159,9 @@
 #define CONFIG_SYS_DDR_SDRAM_CLK_CNTL	(DDR_SDRAM_CLK_CNTL_SS_EN | \
 				DDR_SDRAM_CLK_CNTL_CLK_ADJUST_075)
 
+#define CONFIG_VERY_BIG_RAM
+#define CONFIG_MAX_MEM_MAPPED   ((phys_size_t)256 << 20)
+
 #ifdef CONFIG_HARD_I2C
 #define CONFIG_SPD_EEPROM		/* use SPD EEPROM for DDR setup*/
 #endif
@@ -447,6 +451,7 @@ boards, we say we have two, but don't display a message if we find only one. */
 #define CONFIG_CMD_IRQ
 #define CONFIG_CMD_NET
 #define CONFIG_CMD_PING
+#define CONFIG_CMD_DHCP
 #define CONFIG_CMD_SDRAM
 
 #ifdef CONFIG_COMPACT_FLASH
-- 
1.5.2.5