[U-Boot] [PATCH 2/2] 85xx: Fix how we map DDR memory

[Kumar Gala <galak@kernel.crashing.org>]

Previously we only allowed power-of-two memory sizes and didnt
handle >2G of memory.  Now we will map up to CONFIG_MAX_MEM_MAPPED
and should properly handle any size that we can make in the TLBs
we have available to us

Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
---

This depends on the following two patches:
* Add an architecture specific config.h for common defines
* ppc: Move CONFIG_MAX_MEM_MAPPED to common config.h

 cpu/mpc85xx/tlb.c           |   74 +++++++++++++++---------------------------
 include/asm-ppc/config.h    |    5 ++-
 include/asm-ppc/processor.h |    2 +
 include/configs/MPC8572DS.h |    1 +
 4 files changed, 33 insertions(+), 49 deletions(-)

diff --git a/cpu/mpc85xx/tlb.c b/cpu/mpc85xx/tlb.c
index 25fa9ee..c73bf05 100644
--- a/cpu/mpc85xx/tlb.c
+++ b/cpu/mpc85xx/tlb.c
@@ -132,61 +132,41 @@ void init_addr_map(void)
 unsigned int setup_ddr_tlbs(unsigned int memsize_in_meg)
 {
 	unsigned int tlb_size;
-	unsigned int ram_tlb_index;
-	unsigned int ram_tlb_address;
+	unsigned int ram_tlb_index = CONFIG_SYS_DDR_TLB_START;
+	unsigned int ram_tlb_address = (unsigned int)CONFIG_SYS_DDR_SDRAM_BASE;
+	unsigned int max_cam = (mfspr(SPRN_TLB1CFG) >> 16) & 0xff;
+	u64 size, memsize = (u64)memsize_in_meg << 20;
 
-	/*
-	 * Determine size of each TLB1 entry.
-	 */
-	switch (memsize_in_meg) {
-	case 16:
-	case 32:
-		tlb_size = BOOKE_PAGESZ_16M;
-		break;
-	case 64:
-	case 128:
-		tlb_size = BOOKE_PAGESZ_64M;
-		break;
-	case 256:
-	case 512:
-		tlb_size = BOOKE_PAGESZ_256M;
-		break;
-	case 1024:
-	case 2048:
-		if (PVR_VER(get_pvr()) > PVR_VER(PVR_85xx))
-			tlb_size = BOOKE_PAGESZ_1G;
-		else
-			tlb_size = BOOKE_PAGESZ_256M;
-		break;
-	default:
-		puts("DDR: only 16M, 32M, 64M, 128M, 256M, 512M, 1G"
-			" and 2G are supported.\n");
-
-		/*
-		 * The memory was not able to be mapped.
-		 * Default to a small size.
-		 */
-		tlb_size = BOOKE_PAGESZ_64M;
-		memsize_in_meg = 64;
-		break;
-	}
+	size = min(memsize, CONFIG_MAX_MEM_MAPPED);
+
+	/* Convert (4^max) kB to (2^max) bytes */
+	max_cam = max_cam * 2 + 10;
+
+	for (; size && ram_tlb_index < 16; ram_tlb_index++) {
+		u32 camsize = __ilog2_u64(size) & ~1U;
+		u32 align = __ilog2(ram_tlb_address) & ~1U;
+
+		if (align == -2) align = max_cam;
+		if (camsize > align)
+			camsize = align;
+
+		if (camsize > max_cam)
+			camsize = max_cam;
+
+		tlb_size = (camsize - 10) / 2;
 
-	/*
-	 * Configure DDR TLB1 entries.
-	 * Starting at TLB1 8, use no more than 8 TLB1 entries.
-	 */
-	ram_tlb_index = CONFIG_SYS_DDR_TLB_START;
-	ram_tlb_address = (unsigned int)CONFIG_SYS_DDR_SDRAM_BASE;
-	while (ram_tlb_address < (memsize_in_meg * 1024 * 1024)
-	      && ram_tlb_index < 16) {
 		set_tlb(1, ram_tlb_address, ram_tlb_address,
 			MAS3_SX|MAS3_SW|MAS3_SR, 0,
 			0, ram_tlb_index, tlb_size, 1);
 
-		ram_tlb_address += (0x1000 << ((tlb_size - 1) * 2));
-		ram_tlb_index++;
+		size -= 1ULL << camsize;
+		memsize -= 1ULL << camsize;
+		ram_tlb_address += 1UL << camsize;
 	}
 
+	if (memsize)
+		printf("%lldM left unmapped\n", memsize >> 20);
+
 	/*
 	 * Confirm that the requested amount of memory was mapped.
 	 */
diff --git a/include/asm-ppc/config.h b/include/asm-ppc/config.h
index 6d27cb1..5640b39 100644
--- a/include/asm-ppc/config.h
+++ b/include/asm-ppc/config.h
@@ -22,8 +22,9 @@
 #define _ASM_CONFIG_H_
 
 #ifndef CONFIG_MAX_MEM_MAPPED
-#if defined(CONFIG_SDRAM_PPC4xx_IBM_DDR2) && defined(CONFIG_SPD_EEPROM)
-#define CONFIG_MAX_MEM_MAPPED	((phys_size_t)2 << 30)
+#if (defined(CONFIG_SDRAM_PPC4xx_IBM_DDR2) && defined(CONFIG_SPD_EEPROM)) || \
+	defined(CONFIG_E500)
+#define CONFIG_MAX_MEM_MAPPED	((phys_size_t)2u << 30)
 #else
 #define CONFIG_MAX_MEM_MAPPED (256 << 20)
 #endif
diff --git a/include/asm-ppc/processor.h b/include/asm-ppc/processor.h
index e07e5d3..4203ada 100644
--- a/include/asm-ppc/processor.h
+++ b/include/asm-ppc/processor.h
@@ -451,6 +451,8 @@
 #define   L2CSR0_L2LO		0x00000020	/* L2 Cache Lock Overflow */
 #define SPRN_L2CSR1	0x3fa	/* L2 Data Cache Control and Status Register 1 */
 
+#define SPRN_TLB0CFG	0x2B0	/* TLB 0 Config Register */
+#define SPRN_TLB1CFG	0x2B1	/* TLB 1 Config Register */
 #define SPRN_MMUCSR0	0x3f4	/* MMU control and status register 0 */
 #define SPRN_MAS0	0x270	/* MMU Assist Register 0 */
 #define SPRN_MAS1	0x271	/* MMU Assist Register 1 */
diff --git a/include/configs/MPC8572DS.h b/include/configs/MPC8572DS.h
index ac0a464..a2360d8 100644
--- a/include/configs/MPC8572DS.h
+++ b/include/configs/MPC8572DS.h
@@ -103,6 +103,7 @@ extern unsigned long get_board_ddr_clk(unsigned long dummy);
 
 /* DDR Setup */
 #define CONFIG_SYS_DDR_TLB_START 9
+#define CONFIG_VERY_BIG_RAM
 #define CONFIG_FSL_DDR2
 #undef CONFIG_FSL_DDR_INTERACTIVE
 #define CONFIG_SPD_EEPROM		/* Use SPD EEPROM for DDR setup */
-- 
1.5.6.6