[U-Boot] [PATCH][v2] ep8248: add support for device tree and secondary Ethernet interface.

Peter Tyser
2009-09-04T14:51:58Z

Hi Marcel,
This patch also appears to be line wrapped.

Best,
Peter

On Fri, 2009-09-04 at 14:41 +0000, Marcel ziswiler wrote:
> Signed-off-by: Marcel Ziswiler <marcel.ziswiler@noser.com>
> ---
> board/ep8248/ep8248.c | 22 +++++++++++++++++-
> include/configs/ep8248.h | 53 ++++++++++++++++++++--------------------------
> 2 files changed, 43 insertions(+), 32 deletions(-)
>
> diff --git a/board/ep8248/ep8248.c b/board/ep8248/ep8248.c
> index bc20ba7..6a190fe 100644
> --- a/board/ep8248/ep8248.c
> +++ b/board/ep8248/ep8248.c
> @@ -5,6 +5,10 @@
> * Support for Embedded Planet EP8248 boards.
> * Tested on EP8248E.
> *
> + * Copyright (C) 2009 Noser Engineering AG
> + * Marcel Ziswiler <marcel.ziswiler@noser.com>
> + * Added support for device tree and secondary Ethernet interface
> + *
> * See file CREDITS for list of people who contributed to this
> * project.
> *
> @@ -28,6 +32,12 @@
> #include <mpc8260.h>
> #include <ioports.h>
>
> +#if defined(CONFIG_OF_LIBFDT)
> +#include <libfdt.h>
> +#include <libfdt_env.h>
> +#include <fdt_support.h>
> +#endif
> +
> /*
> * I/O Port configuration table
> *
> @@ -35,8 +45,8 @@
> * according to the five values podr/pdir/ppar/psor/pdat for that entry
> */
>
> -#define CONFIG_SYS_FCC1 (CONFIG_ETHER_INDEX == 1)
> -#define CONFIG_SYS_FCC2 (CONFIG_ETHER_INDEX == 2)
> +#define CONFIG_SYS_FCC1 (CONFIG_ETHER_ON_FCC1 == 1)
> +#define CONFIG_SYS_FCC2 (CONFIG_ETHER_ON_FCC2 == 1)
>
> const iop_conf_t iop_conf_tab[4][32] = {
>
> @@ -261,3 +271,11 @@ int checkboard(void)
>
> return 0;
> }
> +
> +#if defined(CONFIG_OF_BOARD_SETUP) && defined(CONFIG_OF_LIBFDT)
> +void ft_board_setup(void *blob, bd_t *bd)
> +{
> + ft_cpu_setup( blob, bd);
> +}
> +#endif /* defined(CONFIG_OF_BOARD_SETUP) && defined(CONFIG_OF_LIBFDT) */
> +
> diff --git a/include/configs/ep8248.h b/include/configs/ep8248.h
> index f7b3fde..b1dbe7d 100644
> --- a/include/configs/ep8248.h
> +++ b/include/configs/ep8248.h
> @@ -4,6 +4,10 @@
> *
> * U-Boot configuration for Embedded Planet EP8248 boards.
> *
> + * Copyright (C) 2009 Noser Engineering AG
> + * Marcel Ziswiler <marcel.ziswiler@noser.com>
> + * Added support for device tree and secondary Ethernet interface
> + *
> * See file CREDITS for list of people who contributed to this
> * project.
> *
> @@ -50,50 +54,41 @@
>
> #define CONFIG_SYS_BCSR 0xFA000000
>
> -/*
> - * Select ethernet configuration
> - *
> - * If either CONFIG_ETHER_ON_SCC or CONFIG_ETHER_ON_FCC is selected,
> - * then CONFIG_ETHER_INDEX must be set to the channel number (1-4 for
> - * SCC, 1-3 for FCC)
> - *
> - * If CONFIG_ETHER_NONE is defined, then either the ethernet routines
> - * must be defined elsewhere (as for the console), or CONFIG_CMD_NET
> - * must be unset.
> - */
> +/* Pass open firmware flat device tree */
> +#define CONFIG_OF_LIBFDT 1
> +#define CONFIG_OF_BOARD_SETUP 1
> +
> +#define OF_TBCLK (bd->bi_busfreq / 4)
> +#define OF_STDOUT_PATH "/soc/cpm/serial at 11a80"
> +
> +/* Select ethernet configuration */
> #undef CONFIG_ETHER_ON_SCC /* Ethernet is not on SCC */
> #define CONFIG_ETHER_ON_FCC /* Ethernet is on FCC */
> #undef CONFIG_ETHER_NONE /* No external Ethernet */
>
> -#ifdef CONFIG_ETHER_ON_FCC
> -
> -#define CONFIG_ETHER_INDEX 1 /* FCC1 is used for Ethernet */
> -
> -#if (CONFIG_ETHER_INDEX == 1)
> +#define CONFIG_NET_MULTI
> +#define CONFIG_SYS_CPMFCR_RAMTYPE 0
> +#define CONFIG_SYS_FCC_PSMR (FCC_PSMR_FDE | FCC_PSMR_LPB)
>
> +#define CONFIG_HAS_ETH0
> +#define CONFIG_ETHER_ON_FCC1 1
> /* - Rx clock is CLK10
> * - Tx clock is CLK11
> * - BDs/buffers on 60x bus
> * - Full duplex
> */
> -#define CONFIG_SYS_CMXFCR_MASK (CMXFCR_FC1 | CMXFCR_RF1CS_MSK | CMXFCR_TF1CS_MS
> K)
> -#define CONFIG_SYS_CMXFCR_VALUE (CMXFCR_RF1CS_CLK10 | CMXFCR_TF1CS_CLK11
> )
> -#define CONFIG_SYS_CPMFCR_RAMTYPE 0
> -#define CONFIG_SYS_FCC_PSMR (FCC_PSMR_FDE | FCC_PSMR_LPB)
> -
> -#elif (CONFIG_ETHER_INDEX == 2)
> +#define CONFIG_SYS_CMXFCR_MASK1 (CMXFCR_FC1 | CMXFCR_RF1CS_MSK | CMXFCR_
> TF1CS_MSK)
> +#define CONFIG_SYS_CMXFCR_VALUE1 (CMXFCR_RF1CS_CLK10 | CMXFCR_TF1CS_CLK11
> )
>
> +#define CONFIG_HAS_ETH1
> +#define CONFIG_ETHER_ON_FCC2 1
> /* - Rx clock is CLK13
> * - Tx clock is CLK14
> * - BDs/buffers on 60x bus
> * - Full duplex
> */
> -#define CONFIG_SYS_CMXFCR_MASK (CMXFCR_FC2 | CMXFCR_RF2CS_MSK | CMXFCR_TF2CS_MS
> K)
> -#define CONFIG_SYS_CMXFCR_VALUE (CMXFCR_RF2CS_CLK13 | CMXFCR_TF2CS_CLK14
> )
> -#define CONFIG_SYS_CPMFCR_RAMTYPE 0
> -#define CONFIG_SYS_FCC_PSMR (FCC_PSMR_FDE | FCC_PSMR_LPB)
> -
> -#endif /* CONFIG_ETHER_INDEX */
> +#define CONFIG_SYS_CMXFCR_MASK2 (CMXFCR_FC2 | CMXFCR_RF2CS_MSK | CMXFCR_
> TF2CS_MSK)
> +#define CONFIG_SYS_CMXFCR_VALUE2 (CMXFCR_RF2CS_CLK13 | CMXFCR_TF2CS_CLK14
> )
>
> #define CONFIG_MII /* MII PHY management */
> #define CONFIG_BITBANGMII /* Bit-banged MDIO interface */
> @@ -113,8 +108,6 @@
>
> #define MIIDELAY udelay(1)
>
> -#endif /* CONFIG_ETHER_ON_FCC */
> -
> #ifndef CONFIG_8260_CLKIN
> #define CONFIG_8260_CLKIN 66000000 /* in Hz */
> #endif
> --
> 1.4.4.4
>
>
> _______________________________________________
> U-Boot mailing list
> U-Boot at lists.denx.de
> http://lists.denx.de/mailman/listinfo/u-boot