[U-Boot] [PATCH] tsec: Force TBI PHY to 1000Mbps full duplex in SGMII mode

[Peter Tyser <ptyser@xes-inc.com>]

On Tue, 2009-11-03 at 17:52 -0600, Peter Tyser wrote:
> In SGMII mode the link between a processor's internal TBI PHY and an
> external PHY should always be 1000Mbps, full duplex.  Also, the SGMII
> interface between an internal TBI PHY and external PHY does not
> support in-band auto-negotation.
> 
> Previously, when configured for SGMII mode a TBI PHY would attempt to
> restart auto-negotation during initializtion.  This auto-negotation
> between a TBI PHY and external PHY would fail and result in unusable
> ethernet operation.
> 
> Forcing the TBI PHY and and external PHY to link at 1000Mbps full duplex
> in SGMII mode resolves this issue of auto-negotation failing.
> 
> Note that 10Mbps and 100Mbps operation is still possible on the external
> side of the external PHY even when SGMII is operating at 1000Mbps.
> The SGMII interface still operates at 1000Mbps, but each byte of data
> is repeated 100 or 10 times for 10/100Mbps and the external PHY handles
> converting this data stream into proper 10/100Mbps signalling.
> 
> Signed-off-by: Peter Tyser <ptyser@xes-inc.com>
> ---
> In-band SGMII auto-negotiation doesn't work according to a lengthy
> discussion with a Freescale FAE and the AN3869 SGMII appnote.  XES's
> MPC8572 and MPC8640 boards need this patch in order to use ethernet. These
> boards generally use SGMII to connect to an BCM5482S PHY which has
> an external gigabit-capable copper or fiber interface.

I meant to say "XES's MPC8572 boards need this patch in order to use
ethernet, and I assume our future 4080-based boards will too."  This
change shouldn't have any impact on 8640-based boards.

Peter