[U-Boot] [PATCH 7/9] USB: EHCI: Allow EHCI post-powerup configuration in board files

[Marek Vasut <marek.vasut@gmail.com>]

This patch allows USB to work on some hosts, which need additional frobing after
the host was powered up via regular USB powerup sequence.

Signed-off-by: Marek Vasut <marek.vasut@gmail.com>
Cc: Stefano Babic <sbabic@denx.de>
Cc: Remy Bohmer <linux@bohmer.net>
Cc: Wolfgang Grandegger <wg@denx.de>
Cc: Jason Liu <r64343@freescale.com>
---
 drivers/usb/host/ehci-hcd.c |   12 ++++++++++--
 1 files changed, 10 insertions(+), 2 deletions(-)

diff --git a/drivers/usb/host/ehci-hcd.c b/drivers/usb/host/ehci-hcd.c
index b4c9db8..8bb3ff1 100644
--- a/drivers/usb/host/ehci-hcd.c
+++ b/drivers/usb/host/ehci-hcd.c
@@ -205,6 +205,14 @@ static inline void ehci_invalidate_dcache(struct QH *qh)
 }
 #endif /* CONFIG_EHCI_DCACHE */
 
+void __ehci_powerup_fixup(uint32_t *status_reg, uint32_t *reg)
+{
+	mdelay(50);
+}
+
+void ehci_powerup_fixup(uint32_t *status_reg, uint32_t *reg)
+	__attribute__((weak, alias("__ehci_powerup_fixup")));
+
 static int handshake(uint32_t *ptr, uint32_t mask, uint32_t done, int usec)
 {
 	uint32_t result;
@@ -713,8 +721,8 @@ ehci_submit_root(struct usb_device *dev, unsigned long pipe, void *buffer,
 				 * usb 2.0 specification say 50 ms resets on
 				 * root
 				 */
-				wait_ms(50);
-				/* terminate the reset */
+				ehci_powerup_fixup(status_reg, &reg);
+
 				ehci_writel(status_reg, reg & ~EHCI_PS_PR);
 				/*
 				 * A host controller must terminate the reset
-- 
1.7.7.1