[U-Boot] [PATCH 8/8] microblaze: ll_temac: export xilinx_ll_temac_eth_init() for evaluation

[Stephan Linz <linz@li-pro.net>]

Am Donnerstag, den 23.02.2012, 12:56 +0100 schrieb Michal Simek: 
> Stephan Linz wrote:
> > Signed-off-by: Stephan Linz <linz@li-pro.net>
> > ---
> >  .../xilinx/microblaze-generic/microblaze-generic.c |   57 ++++++++++++++++++++
> >  drivers/net/xilinx_ll_temac.c                      |    2 +-
> >  include/xilinx_ll_temac.h                          |    3 +
> >  3 files changed, 61 insertions(+), 1 deletions(-)
> > 
> > diff --git a/board/xilinx/microblaze-generic/microblaze-generic.c b/board/xilinx/microblaze-generic/microblaze-generic.c
> > index 517b2f1..d2f56b9 100644
> > --- a/board/xilinx/microblaze-generic/microblaze-generic.c
> > +++ b/board/xilinx/microblaze-generic/microblaze-generic.c
> > @@ -31,6 +31,10 @@
> >  #include <asm/microblaze_intc.h>
> >  #include <asm/asm.h>
> >  
> > +#ifdef CONFIG_XILINX_LL_TEMAC
> > +#include <xilinx_ll_temac.h>
> > +#endif
> > +
> >  int do_reset(cmd_tbl_t *cmdtp, int flag, int argc, char * const argv[])
> >  {
> >  #ifdef CONFIG_SYS_GPIO_0
> > @@ -92,7 +96,60 @@ int board_eth_init(bd_t *bis)
> >  #endif
> >  
> >  #ifdef CONFIG_XILINX_LL_TEMAC
> > +#if 1
> > +	/* This should be the preferred way to initialize
> > +	 * all the interfaces. */
> >  	ret |= xilinx_ll_temac_standard_init(bis);
> 
> if 1 is not the best for mainline because it means that below is dead code.

:) right -- This snippet was only intended for illustration of the
differences


Stephan