[U-Boot] [PATCH 2/2] [v2] net: abort network initialization if the PHY driver fails

[Stephan Linz <linz@li-pro.net>]

Hi Timur,

Am Freitag, den 06.07.2012, 13:35 -0500 schrieb Timur Tabi: 
> Now that phy_startup() can return an actual error code, check for that error
> code and abort network initialization if the PHY fails.
> 
> Signed-off-by: Timur Tabi <timur@freescale.com>
> ---
>  drivers/net/fec_mxc.c         |    7 ++++++-
>  drivers/net/fm/eth.c          |    9 ++++++++-
>  drivers/net/sh_eth.c          |    6 +++++-
>  drivers/net/tsec.c            |    8 +++++++-
>  drivers/net/xilinx_axi_emac.c |    6 +++++-
>  drivers/net/xilinx_ll_temac.c |    8 +++++++-
>  6 files changed, 38 insertions(+), 6 deletions(-)
> 
> diff --git a/drivers/net/fec_mxc.c b/drivers/net/fec_mxc.c
> index eee41d7..e62ae61 100644
> --- a/drivers/net/fec_mxc.c
> +++ b/drivers/net/fec_mxc.c
> @@ -510,7 +510,12 @@ static int fec_open(struct eth_device *edev)
>  		fec_eth_phy_config(edev);
>  	if (fec->phydev) {
>  		/* Start up the PHY */
> -		phy_startup(fec->phydev);
> +		int ret = phy_startup(fec->phydev);
> +		if (ret) {
> +			printf("Could not initialize PHY %s\n",
> +			       fec->phydev->dev->name);
> +			return ret;
> +		}
>  		speed = fec->phydev->speed;
>  	} else {
>  		speed = _100BASET;
> diff --git a/drivers/net/fm/eth.c b/drivers/net/fm/eth.c
> index f34f4db..2b616ad 100644
> --- a/drivers/net/fm/eth.c
> +++ b/drivers/net/fm/eth.c
> @@ -363,6 +363,9 @@ static int fm_eth_open(struct eth_device *dev, bd_t *bd)
>  {
>  	struct fm_eth *fm_eth;
>  	struct fsl_enet_mac *mac;
> +#ifdef CONFIG_PHYLIB
> +	int ret;
> +#endif
>  
>  	fm_eth = (struct fm_eth *)dev->priv;
>  	mac = fm_eth->mac;
> @@ -384,7 +387,11 @@ static int fm_eth_open(struct eth_device *dev, bd_t *bd)
>  	fmc_tx_port_graceful_stop_disable(fm_eth);
>  
>  #ifdef CONFIG_PHYLIB
> -	phy_startup(fm_eth->phydev);
> +	ret = phy_startup(fm_eth->phydev);
> +	if (ret) {
> +		printf("%s: Could not initialize\n", fm_eth->phydev->dev->name);
> +		return ret;
> +	}
>  #else
>  	fm_eth->phydev->speed = SPEED_1000;
>  	fm_eth->phydev->link = 1;
> diff --git a/drivers/net/sh_eth.c b/drivers/net/sh_eth.c
> index bb57e4d..268d884 100644
> --- a/drivers/net/sh_eth.c
> +++ b/drivers/net/sh_eth.c
> @@ -415,7 +415,11 @@ static int sh_eth_config(struct sh_eth_dev *eth, bd_t *bd)
>  		goto err_phy_cfg;
>  	}
>  	phy = port_info->phydev;
> -	phy_startup(phy);
> +	ret = phy_startup(phy);
> +	if (ret) {
> +		printf(SHETHER_NAME ": phy startup failure\n");
> +		return ret;
> +	}
>  
>  	val = 0;
>  
> diff --git a/drivers/net/tsec.c b/drivers/net/tsec.c
> index 3c1c8f0..f5e314b 100644
> --- a/drivers/net/tsec.c
> +++ b/drivers/net/tsec.c
> @@ -480,6 +480,7 @@ static int tsec_init(struct eth_device *dev, bd_t * bd)
>  	int i;
>  	struct tsec_private *priv = (struct tsec_private *)dev->priv;
>  	tsec_t *regs = priv->regs;
> +	int ret;
>  
>  	/* Make sure the controller is stopped */
>  	tsec_halt(dev);
> @@ -511,7 +512,12 @@ static int tsec_init(struct eth_device *dev, bd_t * bd)
>  	startup_tsec(dev);
>  
>  	/* Start up the PHY */
> -	phy_startup(priv->phydev);
> +	ret = phy_startup(priv->phydev);
> +	if (ret) {
> +		printf("Could not initialize PHY %s\n",
> +		       priv->phydev->dev->name);
> +		return ret;
> +	}
>  
>  	adjust_link(priv, priv->phydev);
>  
> diff --git a/drivers/net/xilinx_axi_emac.c b/drivers/net/xilinx_axi_emac.c
> index 7854a04..d777144 100644
> --- a/drivers/net/xilinx_axi_emac.c
> +++ b/drivers/net/xilinx_axi_emac.c
> @@ -272,7 +272,11 @@ static int setup_phy(struct eth_device *dev)
>  	phydev->advertising = phydev->supported;
>  	priv->phydev = phydev;
>  	phy_config(phydev);
> -	phy_startup(phydev);
> +	if (phy_startup(phydev)) {
> +		printf("axiemac: could not initialize PHY %s\n",
> +		       phydev->dev->name);
> +		return 0;
> +	}
>  
>  	switch (phydev->speed) {
>  	case 1000:
> diff --git a/drivers/net/xilinx_ll_temac.c b/drivers/net/xilinx_ll_temac.c
> index 27dafc1..b67153b 100644
> --- a/drivers/net/xilinx_ll_temac.c
> +++ b/drivers/net/xilinx_ll_temac.c
> @@ -232,6 +232,7 @@ static void ll_temac_halt(struct eth_device *dev)
>  static int ll_temac_init(struct eth_device *dev, bd_t *bis)
>  {
>  	struct ll_temac *ll_temac = dev->priv;
> +	int ret;
>  
>  	printf("%s: Xilinx XPS LocalLink Tri-Mode Ether MAC #%d at 0x%08X.\n",
>  		dev->name, dev->index, dev->iobase);
> @@ -240,7 +241,12 @@ static int ll_temac_init(struct eth_device *dev, bd_t *bis)
>  		return -1;
>  
>  	/* Start up the PHY */
> -	phy_startup(ll_temac->phydev);
> +	ret = phy_startup(ll_temac->phydev);
> +	if (ret) {
> +		printf("%s: Could not initialize PHY %s\n",
> +		       dev->name, ll_temac->phydev->dev->name);
> +		return ret;
> +	}
>  
>  	if (!ll_temac_adjust_link(dev)) {
>  		ll_temac_halt(dev);
I acked Xilinx part, xilinx_axi_emac and xilinx_ll_temac. Thank you.

Acked-by: Stephan Linz <linz@li-pro.net>

br,
Stephan