[U-Boot] [PATCH] mx6: clock: Only show CSPI clock if CSPI is enabled

[Fabio Estevam <festevam@gmail.com>]

From: Fabio Estevam <fabio.estevam@freescale.com>

If a board does not enable CSPI, there is no need to show the CSPI clock 
frequency as part of the 'clock' command.

Reported-by: Dirk Behme <dirk.behme@gmail.com>
Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>
---
 arch/arm/cpu/armv7/mx6/clock.c |    2 ++
 1 file changed, 2 insertions(+)

diff --git a/arch/arm/cpu/armv7/mx6/clock.c b/arch/arm/cpu/armv7/mx6/clock.c
index a01d96f..a50db70 100644
--- a/arch/arm/cpu/armv7/mx6/clock.c
+++ b/arch/arm/cpu/armv7/mx6/clock.c
@@ -404,7 +404,9 @@ int do_mx6_showclocks(cmd_tbl_t *cmdtp, int flag, int argc, char * const argv[])
 	printf("\n");
 	printf("IPG        %8d kHz\n", mxc_get_clock(MXC_IPG_CLK) / 1000);
 	printf("UART       %8d kHz\n", mxc_get_clock(MXC_UART_CLK) / 1000);
+#ifdef CONFIG_MXC_SPI
 	printf("CSPI       %8d kHz\n", mxc_get_clock(MXC_CSPI_CLK) / 1000);
+#endif
 	printf("AHB        %8d kHz\n", mxc_get_clock(MXC_AHB_CLK) / 1000);
 	printf("AXI        %8d kHz\n", mxc_get_clock(MXC_AXI_CLK) / 1000);
 	printf("DDR        %8d kHz\n", mxc_get_clock(MXC_DDR_CLK) / 1000);
-- 
1.7.9.5