[U-Boot] [PATCH 2/6] nand: Add SPL_NAND support to mxc_nand_spl

["Benoît Thébaudeau" <benoit.thebaudeau@advansee.com>]

On Friday, April 19, 2013 5:21:49 PM, Beno?t Th?baudeau wrote:
> Hi Philip,
> 
> On Friday, April 19, 2013 5:09:59 PM,Philip Paeps wrote:
> > On 2013-04-19 16:48:42 (+0200), Philip Paeps <philip@paeps.cx> wrote:
> > > On 2013-04-19 15:00:13 (+0200), Philip Paeps <philip@paeps.cx> wrote:
> > > > On 2013-04-19 06:10:51 (+0200), Marek Vasut <marex@denx.de> wrote:
> > > > > To avoid the old function which are used with the nand_spl/ stuff
> > > > > getting in the way of NAND SPL framework, the macro
> > > > > CONFIG_SPL_NAND_LEGACY was introduced and two remaining legacy
> > > > > boards were adjusted. These board need to be either fixed or
> > > > > removed in the long run, but I don't have either.
> > > > 
> > > > It sounds like "fixing" these boards is mainly a matter of confirming
> > > > that a configuration for them based around CONFIG_SPL_FRAMEWORK will
> > > > fit
> > > > in 2K.  If so, I don't think there is any reason to keep legacy support
> > > > around.
> > > 
> > > A first build with CONFIG_SPL_FRAMEWORK came out to nearly 4K.  Large
> > > contributors being (unsurprisingly) libcommon and libgeneric.  I had to
> > > get rid of a puts() in libspl to make it build without those libraries.
> > > Unfortunately, that still came out to 2.2K.  Close. :-)
> > > 
> > > I couldn't identify any obvious 100 bytes to scrap from glancing at
> > > u-boot-spl.map or objdump -D u-boot-spl, but I'll take a look.
> > 
> > Just as I hit 'send', it occurred to me that this configuration is with
> > a fairly lengthy lowlevel_init.S to support external boot.  Paring that
> > to the bare minimum gives a u-boot-spl.bin of 1821 bytes.
> 
> But this requires a board-specific lowlevel_init() and a hack for puts()
> (which
> is perhaps already solved by Andreas' series), just to bloat the SPL with
> stuff useless for those boards, vs. a simple nand_boot() that can be made
> common
> to all SPLs with size restrictions.

Or, with Andreas' series to get rid of puts(), and with an option to make the
use of spl_parse_image_header() an option (i.e. to be able to force raw binary
SPL payload format), the change would be almost equivalent to using the current
nand_boot(), so the size should follow.

Best regards,
Beno?t