[U-Boot] [PATCH 4/4] ti814x_evm: enable CPSW support

[Matt Porter <mporter@ti.com>]

Adds CPSW support to the TI814X EVM configured with
an ET1011C PHY in GMII mode.

Signed-off-by: Matt Porter <mporter@ti.com>
---
 board/ti/ti814x/evm.c        |   72 ++++++++++++++++++++++++++++++++++++++++++
 board/ti/ti814x/evm.h        |    1 +
 board/ti/ti814x/mux.c        |   35 ++++++++++++++++++++
 include/configs/ti814x_evm.h |   21 ++++++++++++
 4 files changed, 129 insertions(+)

diff --git a/board/ti/ti814x/evm.c b/board/ti/ti814x/evm.c
index 8513220..d6c19f5 100644
--- a/board/ti/ti814x/evm.c
+++ b/board/ti/ti814x/evm.c
@@ -17,6 +17,7 @@
  */
 
 #include <common.h>
+#include <cpsw.h>
 #include <errno.h>
 #include <spl.h>
 #include <asm/arch/cpu.h>
@@ -39,6 +40,8 @@ static struct wd_timer *wdtimer = (struct wd_timer *)WDT_BASE;
 static struct uart_sys *uart_base = (struct uart_sys *)DEFAULT_UART_BASE;
 #endif
 
+static struct ctrl_dev *cdev = (struct ctrl_dev *)CTRL_DEVICE_BASE;
+
 /* UART Defines */
 #ifdef CONFIG_SPL_BUILD
 #define UART_RESET		(0x1 << 1)
@@ -166,6 +169,9 @@ void s_init(void)
 	/* Set MMC pins */
 	enable_mmc1_pin_mux();
 
+	/* Set Ethernet pins */
+	enable_enet_pin_mux();
+
 	/* Enable UART */
 	uart_enable();
 
@@ -199,3 +205,69 @@ int board_mmc_init(bd_t *bis)
 	return 0;
 }
 #endif
+
+#ifdef CONFIG_DRIVER_TI_CPSW
+static void cpsw_control(int enabled)
+{
+	/* VTP can be added here */
+
+	return;
+}
+
+static struct cpsw_slave_data cpsw_slaves[] = {
+	{
+		.slave_reg_ofs	= 0x50,
+		.sliver_reg_ofs	= 0x700,
+		.phy_id		= 1,
+	},
+	{
+		.slave_reg_ofs	= 0x90,
+		.sliver_reg_ofs	= 0x740,
+		.phy_id		= 0,
+	},
+};
+
+static struct cpsw_platform_data cpsw_data = {
+	.mdio_base		= CPSW_MDIO_BASE,
+	.cpsw_base		= CPSW_BASE,
+	.mdio_div		= 0xff,
+	.channels		= 8,
+	.cpdma_reg_ofs		= 0x100,
+	.slaves			= 1,
+	.slave_data		= cpsw_slaves,
+	.ale_reg_ofs		= 0x600,
+	.ale_entries		= 1024,
+	.host_port_reg_ofs	= 0x28,
+	.hw_stats_reg_ofs	= 0x400,
+	.mac_control		= (1 << 5),
+	.control		= cpsw_control,
+	.host_port_num		= 0,
+	.version		= CPSW_CTRL_VERSION_1,
+};
+#endif
+
+int board_eth_init(bd_t *bis)
+{
+	uint8_t mac_addr[6];
+	uint32_t mac_hi, mac_lo;
+
+	if (!eth_getenv_enetaddr("ethaddr", mac_addr)) {
+		printf("<ethaddr> not set. Reading from E-fuse\n");
+		/* try reading mac address from efuse */
+		mac_lo = readl(&cdev->macid0l);
+		mac_hi = readl(&cdev->macid0h);
+		mac_addr[0] = mac_hi & 0xFF;
+		mac_addr[1] = (mac_hi & 0xFF00) >> 8;
+		mac_addr[2] = (mac_hi & 0xFF0000) >> 16;
+		mac_addr[3] = (mac_hi & 0xFF000000) >> 24;
+		mac_addr[4] = mac_lo & 0xFF;
+		mac_addr[5] = (mac_lo & 0xFF00) >> 8;
+
+		if (is_valid_ether_addr(mac_addr))
+			eth_setenv_enetaddr("ethaddr", mac_addr);
+		else
+			printf("Unable to read MAC address. Set <ethaddr>\n");
+	}
+
+	return cpsw_register(&cpsw_data);
+}
diff --git a/board/ti/ti814x/evm.h b/board/ti/ti814x/evm.h
index 40f8710..6aebec6 100644
--- a/board/ti/ti814x/evm.h
+++ b/board/ti/ti814x/evm.h
@@ -3,5 +3,6 @@
 
 void enable_uart0_pin_mux(void);
 void enable_mmc1_pin_mux(void);
+void enable_enet_pin_mux(void);
 
 #endif /* _EVM_H */
diff --git a/board/ti/ti814x/mux.c b/board/ti/ti814x/mux.c
index 137acb4..fd9f364 100644
--- a/board/ti/ti814x/mux.c
+++ b/board/ti/ti814x/mux.c
@@ -40,6 +40,36 @@ static struct module_pin_mux mmc1_pin_mux[] = {
 	{-1},
 };
 
+static struct module_pin_mux enet_pin_mux[] = {
+	{OFFSET(pincntl232), MODE(0x01)},		/* EMAC_RMREFCLK */
+	{OFFSET(pincntl233), PULLUP_EN | MODE(0x01)},	/* MDCLK */
+	{OFFSET(pincntl234), PULLUP_EN | MODE(0x01)},	/* MDIO */
+	{OFFSET(pincntl235), MODE(0x01)},		/* EMAC[0]_MTCLK */
+	{OFFSET(pincntl236), MODE(0x01)},		/* EMAC[0]_MCOL */
+	{OFFSET(pincntl237), MODE(0x01)},		/* EMAC[0]_MCRS */
+	{OFFSET(pincntl238), MODE(0x01)},		/* EMAC[0]_MRXER */
+	{OFFSET(pincntl239), MODE(0x01)},		/* EMAC[0]_MRCLK */
+	{OFFSET(pincntl240), MODE(0x01)},		/* EMAC[0]_MRXD[0] */
+	{OFFSET(pincntl241), MODE(0x01)},		/* EMAC[0]_MRXD[1] */
+	{OFFSET(pincntl242), MODE(0x01)},		/* EMAC[0]_MRXD[2] */
+	{OFFSET(pincntl243), MODE(0x01)},		/* EMAC[0]_MRXD[3] */
+	{OFFSET(pincntl244), MODE(0x01)},		/* EMAC[0]_MRXD[4] */
+	{OFFSET(pincntl245), MODE(0x01)},		/* EMAC[0]_MRXD[5] */
+	{OFFSET(pincntl246), MODE(0x01)},		/* EMAC[0]_MRXD[6] */
+	{OFFSET(pincntl247), MODE(0x01)},		/* EMAC[0]_MRXD[7] */
+	{OFFSET(pincntl248), MODE(0x01)},		/* EMAC[0]_MRXDV */
+	{OFFSET(pincntl249), MODE(0x01)},		/* EMAC[0]_GMTCLK */
+	{OFFSET(pincntl250), MODE(0x01)},		/* EMAC[0]_MTXD[0] */
+	{OFFSET(pincntl251), MODE(0x01)},		/* EMAC[0]_MTXD[1] */
+	{OFFSET(pincntl252), MODE(0x01)},		/* EMAC[0]_MTXD[2] */
+	{OFFSET(pincntl253), MODE(0x01)},		/* EMAC[0]_MTXD[3] */
+	{OFFSET(pincntl254), MODE(0x01)},		/* EMAC[0]_MTXD[4] */
+	{OFFSET(pincntl255), MODE(0x01)},		/* EMAC[0]_MTXD[5] */
+	{OFFSET(pincntl256), MODE(0x01)},		/* EMAC[0]_MTXD[6] */
+	{OFFSET(pincntl257), MODE(0x01)},		/* EMAC[0]_MTXD[7] */
+	{OFFSET(pincntl258), MODE(0x01)},		/* EMAC[0]_MTXEN */
+};
+
 void enable_uart0_pin_mux(void)
 {
 	configure_module_pin_mux(uart0_pin_mux);
@@ -49,3 +79,8 @@ void enable_mmc1_pin_mux(void)
 {
 	configure_module_pin_mux(mmc1_pin_mux);
 }
+
+void enable_enet_pin_mux(void)
+{
+	configure_module_pin_mux(enet_pin_mux);
+}
diff --git a/include/configs/ti814x_evm.h b/include/configs/ti814x_evm.h
index 4cbd789..ce0541a 100644
--- a/include/configs/ti814x_evm.h
+++ b/include/configs/ti814x_evm.h
@@ -217,4 +217,25 @@
 /* Unsupported features */
 #undef CONFIG_USE_IRQ
 
+/* Ethernet */
+#define CONFIG_CMD_NET
+#define CONFIG_CMD_DHCP
+#define CONFIG_CMD_PING
+#define CONFIG_CMD_MII
+#define CONFIG_DRIVER_TI_CPSW
+#define CONFIG_MII
+#define CONFIG_BOOTP_DEFAULT
+#define CONFIG_BOOTP_DNS
+#define CONFIG_BOOTP_DNS2
+#define CONFIG_BOOTP_SEND_HOSTNAME
+#define CONFIG_BOOTP_GATEWAY
+#define CONFIG_BOOTP_SUBNETMASK
+#define CONFIG_NET_RETRY_COUNT         10
+#define CONFIG_NET_MULTI
+#define CONFIG_PHY_GIGE
+#define CONFIG_PHYLIB
+#define CONFIG_PHY_ADDR			1
+#define CONFIG_PHY_ET1011C
+#define CONFIG_PHY_ET1011C_TX_CLK_FIX
+
 #endif	/* ! __CONFIG_TI814X_EVM_H */
-- 
1.7.9.5