[U-Boot] [PATCH v2 1/4] mtd: nand: omap: enable BCH ECC scheme using ELM for generic platform

[Scott Wood <scottwood@freescale.com>]

On Fri, 2013-08-23 at 08:43 -0400, Tom Rini wrote:
> On 08/22/2013 06:25 PM, Scott Wood wrote:
> > On Wed, 2013-08-14 at 11:46 +0530, Pekon Gupta wrote:
> >> BCH8_ECC scheme implemented in omap_gpmc.c driver has following 
> >> two favours 
> >> +-----------------------------------+-----------------+-----------------+
> >>
> >>
> >> 
> |ECC Scheme                         | ECC Calculation | Error Detection |
> >> +-----------------------------------+-----------------+-----------------+
> >>
> >>
> >> 
> |OMAP_ECC_BCH8_CODE_HW              |GPMC             |ELM H/W engine   |
> >> |OMAP_ECC_BCH8_CODE_HW_DETECTION_SW |GPMC             |S/W BCH 
> >> library  | 
> >> +-----------------------------------+-----------------+-----------------+
> >>
> >>
> >>
> >> 
> Current implementation enables of BCH8_CODE_HW only for AM33xx SoC family.
> >> (using CONFIG_AM33XX). However, other SoC families (like TI81xx) 
> >> also have ELM hardware module, and can support ECC error 
> >> detection using ELM.
> >> 
> >> This patch - replaces CONFIG_AM33xx define with 
> >> CONFIG_NAND_OMAP_ECC_BCH8_CODE_HW so that all device families 
> >> having required h/w capability can use ELM for error detection
> >> in ECC_BCHx schemes.
> >> 
> >> - replaces CONFIG_NAND_OMAP_BCH8 with 
> >> CONFIG_NAND_OMAP_ECC_BCH8_CODE_HW_DETECTION_SW && CONFIG_BCH and 
> >> separates out code for above mentioned BCH8_ECC implementations 
> >> so that driver can be build independently using anyone of them. 
> >> CONFIG_BCH is used to enable software BCH library in lib/bch.c
> >> 
> >> Signed-off-by: Pekon Gupta <pekon@ti.com> --- doc/README.nand |
> >> 20 +++++++ drivers/mtd/nand/omap_gpmc.c | 128 
> >> ++++++++++++++++++++++++------------------- 
> >> include/configs/am335x_evm.h |   1 +
> >> include/configs/ti814x_evm.h |   2 +- include/configs/tricorder.h
> >> |   2 +- 5 files changed, 96 insertions(+), 57 deletions(-)
> > 
> > The ti814x_evm.h changes do not apply.  What tree is this against?
> > 
> > Can someone familiar with the OMAP driver review this patchset?
> 
> The ti814x_evm.h part depends on his earlier patch I suspect.  If
> you're happy NAND-wise, I'll pick these up (and formally review 'em, I
> have skimmed) for the TI tree if that works for you.

OK: Acked-by: Scott Wood <scottwood@freescale.com>

-Scott