[U-Boot] [PATCH] watchdog/denali: Adding DesignWare watchdog driver support

[Chin Liang See <clsee@altera.com>]

Hi Albert,

On Fri, 2014-02-21 at 17:58 +0100, ZY - albert.u.boot wrote:
> Hi Chin,
> 
> On Fri, 21 Feb 2014 10:00:08 -0600, Chin Liang See <clsee@altera.com>
> wrote:
> 
> > Hi Albert,
> > 
> > On Thu, 2014-02-13 at 10:35 +0100, ZY - albert.u.boot wrote:
> > > Hi Chin,
> > > 
> > > On Wed, 18 Dec 2013 16:23:35 -0600, Chin Liang See <clsee@altera.com>
> > > wrote:
> > > 
> > > > To add the DesignWare watchdog driver support. It required
> > > > information such as register base address and clock info from
> > > > configuration header file  within include/configs folder.
> > > > 
> > > > Signed-off-by: Chin Liang See <clsee@altera.com>
> > > > Cc: Anatolij Gustschin <agust@denx.de>
> > > > Cc: Albert Aribaud <albert.u.boot@aribaud.net>
> > > > Cc: Heiko Schocher <hs@denx.de>
> > > > Cc: Tom Rini <trini@ti.com>
> > > > ---
> > > >  drivers/watchdog/Makefile         |    1 +
> > > >  drivers/watchdog/designware_wdt.c |   75 +++++++++++++++++++++++++++++++++++++
> > > >  2 files changed, 76 insertions(+)
> > > >  create mode 100644 drivers/watchdog/designware_wdt.c
> > > 
> > > As such, this code is dead code in that no board uses this watchdog --
> > > same as the NAND driver series assigned to scott Wood (cc:).
> > > 
> > > If there is a board which uses these drivers, please resubmit the
> > > drivers and board patches in a single series where some board config
> > > is made to use them.
> > > 
> > > Amicalement,
> > 
> > Sorry my bad as I would thought they would need 2 different patches. 
> 
> Actually it could have been two different patches, but in a single
> series (i.e., patch 1/2 provides the driver, patch 2/2 provides the
> configurations which use the driver).
> 

Sure I can do that too. Thanks!

Chin Liang

> > Chin Liang
> 
> Amicalement,