[U-Boot] net/designware: call phy_connect_dev() to properly setup phylib device

[Ian Campbell <ijc@hellion.org.uk>]

On Tue, 2014-05-13 at 07:19 -0400, Tom Rini wrote:
> On Tue, May 13, 2014 at 11:19:13AM +0100, Ian Campbell wrote:
> > On Mon, 2014-05-12 at 21:53 -0400, Tom Rini wrote:
> > > On Mon, Apr 28, 2014 at 08:14:05PM +0100, Ian Campbell wrote:
> > > 
> > > > This sets up the linkage from the phydev back to the ethernet device. This
> > > > symptom of not doing this which I noticed was:
> > > >     <NULL> Waiting for PHY auto negotiation to complete....
> > > > rather than:
> > > >     dwmac.1c50000 Waiting for PHY auto negotiation to complete....
> > > > 
> > > > Signed-off-by: Ian Campbell <ijc@hellion.org.uk>
> > > > Cc: Alexey Brodkin <Alexey.Brodkin@synopsys.com>
> > > 
> > > Applied to u-boot/master, thanks!
> > 
> > Thanks, have you also seen "[PATCH v3 0/5] net/designware: fixes for
> > data cache, phylib and burst size" which included this and some other
> > (far more critical, since designware is currently unusable on ARM)
> > fixes?
> 
> For the moment I've tossed all of the rest of them over to Albert to
> grab along with the sunxi stuff.

OK, thanks. Does that mean they should be delegated to him in patchwork
(because they still say trini)?

> Albert, if you're uncomfortable there
> I can pick them up instead, thanks!

Cheers,
Ian.