[U-Boot] Standalone application issue.

[mazen.e <mazen.ezzeddine@gmail.com>]

Dear Wolfang,


Dear Wolfang,

Thank you very much for the time your are investing replying to my messages.

Here is the command I am using to make the image :

mkimage -A arm -O u-boot -T standalone -C none -a c1000000 -e 0c100000 -n
"Hello World" -d hello_world.bin HelloWorld.img


Please note that I checked using nm command that the entry point is actually
0c100000.

Please be advised that in order to transfer the image to the arndale 5250
board, I am launching loadb command (at the default load address 0x43e0000)
and then returning to the kermit window (ctrl \ + c) and finally I am using
the kermit send command for the actual  file transfer. Launching the command
md shows that the file has actually been transferred. To load and execute
the image I am using the command bootm.

Please note that I am using the arndale 5250 KVM uboot version which shall
loads the kernel in hyp mode, with the same configuration

Many thanks and best regards.




--
View this message in context: http://u-boot.10912.n7.nabble.com/Standalone-application-issue-tp180515p180660.html
Sent from the U-Boot mailing list archive at Nabble.com.