[U-Boot] [PATCH 2/5] kbuild: sync mixed targets handling with Linux 3.16-rc1

Jeroen Hofstee
2014-06-16T17:58:28Z

Hello Masahiro,

On ma, 2014-06-16 at 18:56 +0900, Masahiro Yamada wrote:
> "make %_config all" was supported for the first time in U-Boot:
> commit 53bca5ab
> kbuild: support simultaneous board configuration and "make all"
>
> Surprisingly it had not been working in Linux Kernel for a long time.
>
> So I sent back the patch to the Linux Kbuild community and it was
> accepted with a little code improvement, at commit 9319f453.
>
> Now, you can do "make defconfig all" or "make %_defconfig all"
> in Linux too.
>

There is some issue with this in current master I guess. I haven't
bothered too much, but I think the one liner cause gcc to be called even
if both compilers are set to clang. With a separate config and make step
I have never seen such behavior. I only noticed it on FreeBSD though
since gcc is not installed there and actually errors, so it might be
awk / sed related as well.

Anyway, perhaps rings a bell...

Regards,
Jeroen